I think the Easter Bunny is actually the Squirrel in disguise. Evil, I say. And I just put in my order.
Butbutbut how can you say I iz evil? Look how cute I iz!
Ask IMAGINE & S_Steve - Thread :)
- Thread starter Imagine
- Start date
- th_trl_thread_readers 0
- Status
Butbutbut how can you say I iz evil? Look how cute I iz!
Ya know, Wuzz, in some cultures, eating dog is just fine. Or, wolf, in this case.
And only the chocolate bunnies taste good.
Sounds like a tank arrangement may well be in the works. We're all keeping our fingers crossed. Which makes it realllly tricky to type ....
Is it an auto or manual? I've had two autos and after a while I can hear the batteries moving inside the unit if I flick it around like a pencil.
Sent from my ADR6300 using Tapatalk
Hey, is there a clip for the 78mm Volts - like a pocket clip device - like on a pen? I am always having to dig it out of my shirt pocket... It would have to be something that would not scratch up the finish...
Well, a search on "pencil clip" will bring some things up. I have no idea whether any will mar the finish of your Volt.
Good question. Haven't "seen" her around. It's a little scary to leave Volties unattended!
**runs around the room holding scissors and lit matches**
Good question. Haven't "seen" her around. It's a little scary to leave Volties unattended!
The reason I was considering the clip is because so far it has slipped out of my pocket into grout, dirt, sawdust, grass, under the sink, and almost got nailed behind some baseboard this morning. I either need a clip or stop carrying it around with me...
Oh, my. SI isn't going to give me even the slightest chance to cancel my order, heheheh. They've already shipped it!!!
Gotta luv that fast service!
And, yeah, Imagine hasn't been on the forum for 30 hours. (I looked it up
)
Gotta luv that fast service!
And, yeah, Imagine hasn't been on the forum for 30 hours. (I looked it up
)I've carried mine around in my jeans pockets quite a bit. Even went through the airport nuker with one in my pocket (TSA didn't bat an eye). It holds up pretty good. I do keep the sleeve on the cart end, though, as I don't want dirt, grout, grass, pocket lint, etc., to get inside.
There was one pencil clip that had a ball end and had what looked to be a decent adjustable clip that might work ok, and not mar the finish since you don't slide it on. Otherwise, you might end up looking for a plastic pen/pocket protector.
Pocket protector is definitely out - I am not that geeky... I only mentioned it in case others thought it might also be a good idea. I will figure something out. For now, I am leaving it on the counter while I am working. Almost nailing one behind the base board was the last straw...
Hm, heavy duty rubber band, one end through the loop of a clip attached to an ID badge holder that clips on a belt with that pull cable thingamabob, and the other end wrapped and tied securely to the Volt? Might work in a pinch until a better solution can be had, and pretty handy to snatch up and vape. For that matter, there may be a more logical solution... I have a lanyard specifically built to hold a KR808 battery, has a rubber holder to slip the end of the battery into. I think it was basically designed along the rubber band method, lol. I wouldn't want to tug hard on it, but the rubber holder fits pretty snug, the battery wouldn't go flying unless the holder did too.
Last edited:
- Status
Similar threads
- Locked
