Too much flow for me. I don't wanna say it is "too" much but it is not ideal for me i want it to be a bit more restricted.
Authentic Svoemesto Kayfun Prime
- Thread starter Bronze
- Start date
- th_trl_thread_readers 0
- Status
I also wonder whether a restrictive drip tip may help?
Yes i also own a mini v3 but in a tighter airflow setting it gurgles no matter what i did and plastic screws do not help too. I may try another driptip but the liteplus v2 driptip did not make any difference.
Sounds like on the Mini, that you would almost have to close off the fluid flow to prevent flooding/ gurgling.
thank you. gonna give it a try. I did not try this because i think it won't have anough space to feed the wick
You mean the Prime is still too airy for you even at the tightest setting?
Yes it is. But i am enjoying my liteplus 2 in a tight setting. But i wish that there would be a more restricted option on the prime.
WoW....i'm a tightass when it comes to mtl tightness, but the small setting on the prime is to tight for me ... 
Last edited:
I'm using it in temp control mode. SS, 7 wrap, 2.0 dia, 26 ga.. Comes in at 0.5 ohms. Vape at 430 degrees.
For the most part, 26g kanthal, 2.5mm, about .8 ohms...same as on the km3. I also do 28g builds, same ID and about 1.4 ohms and vape on average 20 watts. I honestly cannot tell the difference between the 2 buildsJust received my Kayfun Prime
I like to vape at lower wattages so I was thinking to build it as I do with the K5: 28g kanthal - 2.5 mm - @ 1.5 ohm
I would like to know how are you guys building it.
Sent from my SCH-I545 using Tapatalk
You can try to place some SS mesh inside the air tube......I suppose if you cut a section, maybe an inch long, by a couple MM wide and rolled it up tight and inserted it down the tube, it would restrict it more. Or perhaps just a little bit inserted at the very topi wish Svoemesto put a 0.8 airflow setting too
Sent from my SCH-I545 using Tapatalk
What other tanks do you use? Are there other rebuildables that are 0.8 or lower? It is refreshing to see that some still enjoy tight draws, as for me, I always considered myself liking tight draws, but under 1mm is super tight, I find 1.6 to 2mm just righti wish Svoemesto put a 0.8 airflow setting too
Sent from my SCH-I545 using Tapatalk
I do this often...start at the smallest setting and take a few draws..go to the next and take a few draws..then open it to the next and take a few draws again..when I get to the fully open setting, it almost tastes like I different juice.
It always amazes me how the flavour profile changes, (and improves) as more air goes through.
This baby is very well designed.
It always amazes me how the flavour profile changes, (and improves) as more air goes through.
This baby is very well designed.
- Status
