GP Series by VapourArt - Official Thread for GP Spheroid, GP PAPS, X, GP Piccolo, GP SnP and more - Part 2
- Thread starter perseas
- Start date
- th_trl_thread_readers 0
- Status
Hey P, got my v-day package all looks great but... My paps x had no parts kit with it...
Did you look in the secret compartment of the holster? One of my rings was hiding there...
That's funny, my ring, Heron parts bag, and silver pins were there too!! I must add that the double holster is beefy!! I don't think I'll wear it on my belt but may travel with it! Are any of you wearing it on your belt? If so, how do you like it?
Sent from my iPad using Tapatalk
Go USA! USA wins it 2-1. Not a great showing but pulled it out.
Now... Question: sup with the gap between body and base on my heron? I don't recall that being normal.
Sent from my iPhone using Tapatalk
Now... Question: sup with the gap between body and base on my heron? I don't recall that being normal.
Sent from my iPhone using Tapatalk
Go USA! USA wins it 2-1. Not a great showing but pulled it out.
Now... Question: sup with the gap between body and base on my heron? I don't recall that being normal.
Sent from my iPhone using Tapatalk
Is your coupler/deck ring screwed down all the way (the piece that the topper snaps onto)? If it's not then you'll have a bit of a gap (ask me how I know!! )
Is your coupler/deck ring screwed down all the way (the piece that the topper snaps onto)? If it's not then you'll have a bit of a gap (ask me how I know!! )
I feel like a buffoon... It was just a slight hair loose. I pinched the outside of the main body and twisted and it turned just a hair and bam...
I blame the beer.
Next to build a better coil. My usual build is a bit higher ohm than normal on here. Usually .8 now at 1. The vape is still nice, but not as flavorful and a little less vapor. Draw is a bit tighter than I am used to as well. Not unpleasantly so, but a bit tighter.
Last edited:
Go USA! USA wins it 2-1. Not a great showing but pulled it out.
Now... Question: sup with the gap between body and base on my heron? I don't recall that being normal.
Sent from my iPhone using Tapatalk
The cotton plate resists the bell on some. Note how flush it is if you pull it out.
Last edited:
That's an idea! Once I loaded my holster with mods and a few access, I knew immediately it was not going on my belt. I am a 32 waist and let's just say that it was a little overwhelming but my wife got a good chuckle, lol!
Sent from my iPad using Tapatalk
Thank you Newfdog, I didnt know about VA doing the Titanium day next and that Id have to wait another month for a boring old reg SS "X"
Your more than welcome, trust me when I say the reg old SS X is far from boring
You'll know what I mean as soon as you hold it and fire that switch for the first time. I'd go and get an account all set up at domo so you have that all taken care of before hand. Good luck
As much as I'd LOVE a Ti, I better let my bank account recover after the last two Vapourdays, lol. With two Xs, a Heron, and two Spheroids, I am very, very ... content.
I am noticing that the double holster will probably need a little break in time. My Paps v3 is a little struggle to insert and remove but the case is definitely durable and great quality as you would expect from the GP team! I sort of hate pulling the Paps out with by the Heron so I am pushing it out from the bottom of the mod just in case!
Sent from my iPad using Tapatalk
Sent from my iPad using Tapatalk
My parts were in the mod itself. And my holster is only a single, I think... But definitely tough nylon. Dont know how much i will use it, as it is nice and tight, and the only way to pull the mod out is by the heron... Which threatens to disconnect the tank. That would prove a mess lol!
- Status
Similar threads
- Locked
- Sticky
- Locked
