Isn't the UFS an upgraded system to replace the AVS? Sure, there is more of a learning curve....and the AVS even a beginner can use....but the new model is so much better. (just wish I could find one!)Its not in my plans to make a longer AVS poppa. Maybe I will not make AVS again at all.
I read some things about fiberglass vanalen (because I had health concerns about it) but there is nothing wrong with it as I see it. If someone has any objection I would like to hear it guys

Isn't the UFS an upgraded system to replace the AVS? Sure, there is more of a learning curve....and the AVS even a beginner can use....but the new model is so much better. (just wish I could find one!)
As for the fiberglass......as long as it's wet I think it would be ok. It's friable when dry....but I don't plan to be playing with longer than to set up a wick and coil. So I don't see an issue with it.
My UFS clear tank didn't hold up. Until the SS replacement arrives I'm using my AVS with few complaints. If it were produced in SS it would be another nice piece to have.
I read some things about fiberglass vanalen (because I had health concerns about it) but there is nothing wrong with it as I see it. If someone has any objection I would like to hear it guys
Jesper, here is what I will use for Iatty: S1RFW1 Braided fiberglass wick approximately 1/16 inch diameter. SKU: 1376-100 Round Fiberglass Wick. Spool size 100 yards. - WickStore.com
If you start getting a burn taste you can do more things than changing wick vanalen. You can refill, overflood, drip, remove the internal cap (and adjust the air (only on GGTS)) the Iatty
Hmm GG4S = GG with four juice compartments? Four atty's that will fill a room with vapor in 0.5 seconds? Four batteries so you can vape and power a laptop at the same time?
How much wick and wire will we get with the iAtty? I'm just planning ahead.
I already ordered wick from aftosa. Now I gotta get me some kanthal
Sent from my DROIDX using Tapatalk
Imeo, have you tested the iAtty with dark flavored juice?
As you probably know, dark juice easily clogs up or carbonizes cartomizers in a matter of days compared to months with clear juice.
Since the iAtty has similar materials as a carto, I'm a bit worried about clogging and longevity.
I think you misunderstood me, I was speaking to a constant burnt or nasty taste, you know what I am saying? I am not saying burnt taste from when the atty is dry but a consistent bad taste that is there even when you drip more on the atty.
