(snipped)
CP, thank you so much for taking the time to reply to me. I saw your comments on MEL's RY4 on another thread and ordered some based on your thoughts.
Now it sounds like I am stalking you.................................I am NOT. LOL
You just seem to be so reasonable and so forthright. Your genuineness (is that a word?) shines through your posts.
I am not afraid to try other devices except for the toppers. I just feel so safe w/ my CE4 types and the Kanger Esmart, v2 Liquid Max and so on. The whole bottom coil/rebuilding/ dual coil/ PT/PT2/davide.............just scare me to death.
I am older (66 next month if anyone would like to start shopping for my bday presents) and my hands are not steady and my eyesight is poor so I need to stick to simplicity for now.
Can. not. wait. for my vapemail from Clark.
Pat
Pat, I don't do rebuilding of coils myself either since as I sort of alluded to in a previous message, I really don't have the time or money or space to take on a new project. Instead, I like that with all of the Kanger toppers I use (Protank I and II, EVOD, and now the new Protank Mini and Mini II), I can buy replacement heads (with the coils already pre-made), remove the old, worn out head, screw the new head into the base, and voila, back to new. At just over a dollar a pop for the replacement heads, it's worth it to me to just do it that way. So the term
rebuilding, as used in this forum, isn't the same as simply replacing the coil heads. While the former refers to actually making the new coil head yourself, the former is simply screwing out the old coil head and putting in the replacement.
BTW, all of the above mentioned Kanger toppers are all
bottom coil, which simply means that the coil is at the bottom of the device just like it is in your ripped out v2 carto. The alternate is called a
vertical coil and when you look inside those, you'll see that the heating coil runs the length of the cartomizer, up and down the filling material if you will. So don't be afraid of the term bottom coil as it simply refers to where the atomizer itself, i.e. the coil part, is located in relation to where you put the e-liquid. See? Easy Peasy!
PS stalk away... I'm flattered actually. Here, I just made it easier for ya by sending you a friend request.
