OK quick update on the BT801-3. This isn't going to pertain to how well it would do modded to bottom feed, but just how it performs as an atty.
1) It's cheap. Really cheap. $3.99 + $2.42 shipping = $5.95.
2) It's cute!
3) I dislike the pos post being a thumb screw. I also dislike the neg screw-capture - just not that into wrapping the end of the wire around a screw and then tightening it down. I prefer a hole
through a post and a screw to tighten down on top. To me that's just more efficient. When you wrap and tighten, it's not rare for the tightening process to squeeze the wire right out. Unless you are holding the other end very tightly as you tighten,which is a pain.
4) The stock air hole is way too small. That's not a problem, but even when I drilled it out to a reasonable size, it still sucked because... it's too low! It's completely misplaced. Lines up with the base/deck, not the coil. Need to drill a whole new hole above it, which would result in two holes on the same side. Not the end of the world, but not that "pretty."
5) Vapes just fine, but nothing to write home about.
Anyways Pdibi my friend, let me now if you want to play with it. I'll stick it in the mail to ya.
You know me, Supe. I was just clarifying on my mission with that particular atty.
is that ↑ for me?
