Sveo Mesto Kayfun Mini V3

Status
Not open for further replies.

VapinAngel

Full Member
Dec 4, 2015
68
40
49
Michigan, US
I switched to this tank about a month ago and am at wits end with it. I have to constantly untwist the top from it to release air bubbles trapped in the chimney otherwise I get a nasty dry hit. Yet the stupid thing is leaking into the overflow chamber on the bottom like it's getting too much juice! I have watched a million tutorials and done everything suggested. Anyone else have any ideas here? Thanks!
 

Two_Bears

Vaping Master
ECF Veteran
Verified Member
Jul 4, 2015
7,045
16,673
Northern Arizona
I switched to this tank about a month ago and am at wits end with it. I have to constantly untwist the top from it to release air bubbles trapped in the chimney otherwise I get a nasty dry hit. Yet the stupid thing is leaking into the overflow chamber on the bottom like it's getting too much juice! I have watched a million tutorials and done everything suggested. Anyone else have any ideas here? Thanks!
I was not inpressed with mine either.

Every top filled Atty i have tried ended up ...... on me!

Because of the Duprodens contracture in three fingers of my left hand i was unable to build on my Serpent Mini. So i sold them on eBay.
 

VapinAngel

Full Member
Dec 4, 2015
68
40
49
Michigan, US
I was not inpressed with mine either.

Every top filled Atty i have tried ended up ...... on me!

Because of the Duprodens contracture in three fingers of my left hand i was unable to build on my Serpent Mini. So i sold them on eBay.


Uh yea! I tried following a tutorial where they covered all the air holes while filling. That was quite the feat with my tiny little girl hands!
 

VapJak

Full Member
Aug 21, 2016
29
69
44
Flooding is due to your wicking style

I use 2.5mm Clapton coil - about 4-5 wraps giving about 0.6-0.8 ohms

I use cotton bacon, Fit it snug but moveable in the coil - trim to just under 1cm each end - carefully fold under so the cotton touches the inside of the juice deck - keep it faily fluffy if you can

Juice the cotton - screw on the tank closed - fill tank - open juice control about 1.5 fill turns - you will see an odd bubble

Vape a little while then open it the extra 1/2 turn (now 2 full tunrs open)

NOW I slightly unscrew the top cap - now you see a couple of big bubbles come up through the liquid - this clears any airlock

Now it is good to go for about a week or so. i find the older the cotton the better the flavour

Hope this helps
 
  • Like
Reactions: BuGlen
Status
Not open for further replies.

Users who are viewing this thread