Do u guys think its possible to drill out my kayfun Lite airhole just a tad bit bigger? I almost atempted it but idk how deep to go.. I also dont want and shavings being trapped in there
Do u guys think its possible to drill out my kayfun Lite airhole just a tad bit bigger? I almost atempted it but idk how deep to go.. I also dont want and shavings being trapped in there
Do u guys think its possible to drill out my Kayfun Lite airhole just a tad bit bigger? I almost atempted it but idk how deep to go.. I also dont want and shavings being trapped in there
Now im thinking of bringing along a cooler to keep it in on my car trips![]()
When you take it out of the cooler, it's gonna do the same thing.![]()
And probably more so.When you take it out of the cooler, it's gonna do the same thing.![]()
Meant to add...
If you don't start vaping right away, yes. The previous post is correct. Then it will leak as it warms up for the same reason. Just vape away when you take it out of the cooler.
Do u guys think its possible to drill out my Kayfun Lite airhole just a tad bit bigger? I almost atempted it but idk how deep to go.. I also dont want and shavings being trapped in there
Ok, first of all, if you take this advice and ruin your KFL I am in no way responsible. I do not own a KFL and this is just a guess based on what I can see on my 3.1. If you take the bottom assembly apart (to the point where 1e in the attached image comes off) you should have the "tube screw" that carries the air to the coil out. Then you should be able to drill the airhole on the outside through. You'll never be able to get a true open draw due to the size of the hole under the coil, but you should be able to loosen it up quite a bit.
![]()
thanks HippieBen..!im going to think about it for a few days and may just do it.. im fine with the air flow now.. but a lil more open would be nice..
p.s. thank u soooo much for uploading ur tutorial on building the kayfun.. i dreaded building the kayfun. it sat there.. i was waiting for a tutorial just like urs.. watched it (a few times) and bam!!! success.... now i got it down. i can set my kayfun up on he first time every time.. less than 10 minutes and im vaping![]()
KFL with 26 gauge nichrome @ 0.8 ohms and cotton ball wick.
![]()
KFL with 26 gauge nichrome @ 0.8 ohms and cotton ball wick.
![]()
thanks HippieBen..!im going to think about it for a few days and may just do it.. im fine with the air flow now.. but a lil more open would be nice..
p.s. thank u soooo much for uploading ur tutorial on building the kayfun.. i dreaded building the kayfun. it sat there.. i was waiting for a tutorial just like urs.. watched it (a few times) and bam!!! success.... now i got it down. i can set my kayfun up on he first time every time.. less than 10 minutes and im vaping![]()
KFL and 3.1 ES tank o-ring size is 17 x 1 mm (Ithaka tank o-ring size is 16 x 1 mm, may work) 17 x 1 mm is recommended for Ithaka when the regular one leaks for no apparent reason.Hi everyone..
Yup, have a question..
Pluid ::: Kayfun lite ::: Swollen O rings :::: Used up all my spares :::
I think the O ring is 4C on some charts. I did a search and got directed to this thread.
I need to know has a solution been found for this or what are the sizes of the O ring?
Could really use some advice on this.
Thanks everyone..