Yeah, I'm finding that out now, wish I hadn't sucked on that thing so hard last night and just swapped it out.
Tank-O-Matic Liquinator v4.1
- Thread starter Wylie
- Start date
- th_trl_thread_readers 0
- Status
Yeah, I'm finding that out now, wish I hadn't sucked on that thing so hard last night and just swapped it out.
Thank you for your response, I will hit up CCV for some new cartos, and find a way to keep them seperated from one another.
Any one else care to share their experience with Fusions? I'm on my second one and it vapes wonderfully but doesn't want to absorb the juice unless I draw on it REALLY HARD. 80/20 PG/VG juice and a decent size single slot made with a rotary tool.
I can't say I've experienced that problem. I've been using Fusions for a long time. Kinda sounds like an air flow issue.
I do know some find using an adapter changes air flow issues.
Good luck and keep us posted.
Someone help me, I'm all dressed up and no place to go. I cut the longer tube for the liquinator and it's just sitting naked and lonely. I want to load it up with 5mls and vape and the CE2 clearomizers are the only XL cartos I have.
I can't say I've experienced that problem. I've been using Fusions for a long time. Kinda sounds like an air flow issue.
I do know some find using an adapter changes air flow issues.
Good luck and keep us posted.
Hmm... I've been using the avidvaper stealth adapter. I'll try a different one. The draw is fine, but it just doesn't wick the juice hardly.
I agree, I wondered myself at the hole size, but it vapes just like as if I had slotted it with my Dremel.
With the jig & punch set, are you guys giving it one hard tap with the hammer or do you give it a couple of taps for each hole?
I have a small nail I got at work and have no idea what size it is but I just give one firm tap and it pops a small hole.
My hubby takes the dremel and does a "score mark" then uses the small nail hole.
Do they work ok?
I appreciate the help Mudflap
I'm not a big fan of the way CE2's wick slowly, but yeah, it works fine. Just make a hole or slot to allow juice to enter the inner chamber of the CE2 to wet the wicks and it works like an unmodded CE2, but only with a larger juice capacity. The diameter of the tube is the same as the 510 & 808 cartos folks are using, so the tank fits on the CE2 just fine.
Note to self:
Don't slot the CE2 before trying in vain to get the tight J Tank connectors on it because they bend and snap.
Do slot the CE2 after the 1 J Tank connector is on by the atty.
the o-rings fit is really crap, they are bulging out on one side and when cleaning the tank putting them back in is a ........Best is to not unscrew the caps anymore, slide new carto's in and out...
I got it in, but you're right, it's a ...... Does'nt the tank get a little funky if you don't clean it out? I've been taking the caps off and rinsing out the tank each time I fill. May try your solution now and just leave the caps on. Can't see futzing with those o rings every time I fill it up.
I have yet to clean the inside of mine out due to fact that I might screw up the O rings. I do wonder if it will get "funky". Or is it like a old cast iron pan and seasoned? hehe
I never take the caps off because they're nasty to get on and off and they can mess up the o-rings IMO. I do wash my tanks out but only once a week, and when I do wash them out I still dont remove those outer caps.
- Status
Similar threads
