24g Nichrome gets crazy low and in a hurry when making duals, make sure you got some 30amp batteries ready or atleast en route with your wire. Enjoy it though and get ready for the heat
Right on. I do have a 30A on the way but it's efest and I wasn't planning on going over 20A with it. My mnkes can handle up to 20 but I'm more comfortable with maybe 15 or 16. So I don't plan to go below 0.4 maybe 0.3 ohm at the lowest. I'm prepared for the heat. Bring it on! I'm used to the hot smoke.what he said^^
18mg nic chokes you on any of my latest builds
Mainly what I'm trying to do is see if I can lower my nic%. I've gone from 24 to 18 in two years- sometimes I can get away with 12 but rarely. I think with a few nice sub builds I can do 12 easily. I am well stocked on 18 so that's concerning but then again I do like the extra buzz as it was mentioned earlier.
too much heat needs more air![]()
I dig big air holes. I like dual 5/64" but wouldn't mind it a bit larger if I needed it. My only problem is bumming drills off of people
