Good thing you stopped...we start interventions when your stash gets up to 26.
I am glad you stopped me. I don't want to suffer the punishment for exceeding that number. 25 stash mods and close to that for kayfuns.
Sounds like you're >< *almost* ready for doomsday.
....besides....Canada is a little far for me.
We'd have to send Willy and he's way over the limit.
We'd have to send Willy and he's way over the limit.
Sounds like you're >< *almost* ready for doomsday.
Almost
Need to figure out juice and decide on a few provaris.
There will be an announcement on vaping by Health Canada by christmas. So will have to wait til then.
Hopefully things will go better for you than it has here.
I'm still hopeful that something will turn all/most of this around, but I'm ready if nothing changes and it all goes away...not mentally ready, but I'm stocked up, and as ready as I can be as far as equipment and supplies.
I'm definitely thinking closer to 15% on the next batch,at 10% it is very faint,i can taste enough to tell it's there,but just too lite right now.
I have really high hope for a few of them.The blueberry muffin smells amazing,so i hope it tastes the same as it smells,the creme brulee i really hope comes out good,that is one of my favorite juice flavors when it's done right so i hope they nailed that one,and the coconut cream and lemon meringue pies.If those 4 come out good,i will be ecstatic haha,then if the rest turn out good,that will just be a huge added bonus.The idea of only having to add 1 flavor and get a good vapable juice will make me happy as it is a lot easier than adding 5-6 different flavors every time.The RF are fabulous !
Are you guys mixing these high vg? I normally mix CAP flavors at the most 5 % but i use 50pg 50 vg. Just ordered some and was thinking of starting at around 6%?
check the rf site reviews and recipe site I am not allowed to mention recommended percents. the rf vg flavors most use at 10 - 15% as single flavors, the raw extracts much lower, in the 1 - 3% range.
I mix all my juice at 30pg/70vg.These Real flavors are vg based and take a bit higher % from what i've read,at 10% the bread pudding is way to lite to me,but you could start at 6% it may be enough for your taste buds.They also have extracts of some flavors,and those are used like 1-3%.
How do those of you at high watts even taste the juice at those percentages? I mix at high ratio but at 45w in a Melo tank, I can barely tell what is in the tank. Same mix in a nauti, kabuki or even an evod tastes incredible. It doesn't taste bad in the Melo, just rather plain.
I stopped buying kayfuns before I got out of control, they can be addictive........I stopped at 25
I think your good for now , one more and you would of been on your way to being out of control so it's good you stopped.
If you have some silicone insulators, you may be able to squeeze them and insert into air holes to cut down air flow. I've used ProTank 2 insulators. Sometimes just one, sometimes two.
Also, I've cut the flange around a rubber ? insulator and inserted into the air hole situated under the coil to restrict incoming air. Sometimes doing that is enough. 
Similar threads
