Attack of the (Kayfun v4) Clones!
- Thread starter KTMRider
- Start date
- th_trl_thread_readers 0
- Status
I'm by no means an expert but I've been using a couple of temp control mods for a while now. I don't know if I would say that it's a ton better. I do like the steady temperature of the vape where with kanthal in wattage mode it seems like it gets a little hotter if you chain vape. I've had a little bit of problem getting my nickel coils to come out to the resistance I wanted even using steam engine calculator. I think I got some bad wire the first time. I like the nickel better than the titanium. My mods don't have a program for stainless steel but I did try a stainless steel coil in a crown tank and really liked it at about 20 watts. I've run nickel coils in my kfl+ but haven't tried it in a kf4. I have noticed that temp control seems to make my coils and wicks last longer. I pulled apart a kfl+ I had been running a few weeks and the coil was still bright and shiny. I still like both kanthal and temp control. It just depends on the tank and the application. I don't think I'll be giving up either.
Any chance you can take a couple pictures of your build? Kind of sounds to me like your not getting full saturation of your wick. In my experience the KF4 does not like thick tails in the well. I also very much prefer 3mm coils in it, 2mm, or even 2.5mm is a bit small for my preference, always ended up with low saturated hits. Not dry, just a bit flavorless.
The KF4 does really well for flavor, it does have a bit of learning curve on wicking though.
haha I could try, taking the pictures are easy, loading them is what I struggle....must be an old 31 year old
As long as they're not to large for the board, you can just drag and drop them into a reply box.
Anyone ever hear of an Ivogo KF4 clone? I have not until recently where someone says it's better than the Tobeco.
The Ivogo was well done, it seemed to review well over on FT, it was sold as 316SS. I never bought one mostly because my experience with Ivogo was a big hit & miss. If you can actually find one reasonably priced it would probably be worthwhile. Better then the Tobeco? Maybe, but then again all my Tobecos are still pretty decent, and still no issues.
Discontinued for quite a while....
$21.76 Kayfun V4 Styled RTA Rebuildable Tank Atomizer - 316 stainless steel / 23.3mm diameter at FastTech - Worldwide Free Shipping
Discontinued for quite a while....
$21.76 Kayfun V4 Styled RTA Rebuildable Tank Atomizer - 316 stainless steel / 23.3mm diameter at FastTech - Worldwide Free Shipping
I bought one of those 316ss KFv4's and I wasn't impressed. I have 6 mods in rotation and a Tobeco replaced the 316ss when I got the $5 closeouts. It's collecting dust along with the 1st FT and FC clones.
Yea, KTMRider's experience is pretty much why I stayed away, Hit & Miss, I bought 5 Ivogo KF Minis, 2 of the Babys, all the minis were great, babies not so much, and the Nemi clones were all on the not so good side as well.
I've been using one of those that I bought from GearBest. Can't complain, it's been good for over six months, smooth, best description.
What's everyone using now??? I've been using the Gems lately. Tried the Erlkonigins and was not impressed.
- Status
