E2 Cartomizer Technical Discussion
- Thread starter zoiDman
- Start date
- th_trl_thread_readers 0
- Status
Shouldn't these be called the E4?..lol...thanks for sending that out, sending yours tomorrow.
your 808 adapter is screwed on, youll see it, if the draw is to tight ill show you how to mod the adapter in 30 seconds, its a new adapter but all the ones i recieved had a tight draw and i used my needle nose scissors to cut out any silicone by the holes inside the center pin.
Last edited:
Hey Turbo did you get a chance to check your M-series carto? Does it hold as much as the other XL's?
I ain't gonna tell you to fill it up John. You'll have to make that decision all by yourself.Oh
Ok the pics are ready, I use clamps but I need to know if it's going to leak, before I fill it up. Right now there is no glue, no silicone, just the mod. Should I go ahead and fill it?
Thanks for the pic and 'banjo', not yet, still vaping on an 808 but will let you know.
E-liquid.cn just listed 401 XL's in 3 ohm choices...
1.7ml vs 1.8ml for the 510 XL.
1.7ml vs 1.8ml for the 510 XL.
yup and the new 100 pc per order is permanent
but with the 510 and 808, they perform the same, why would the 401 be any different, its based off the same cup and wick principal.
before each atomizer was built slightly different, 901 had a washer in them, 510's looked one way while the 801 was bigger, so they should perform different. but all the E2's are built the same, a cup with the coil around a wick that sits int he tank inside a metal tube.
so they should all essentially perform the same.
but with the 510 and 808, they perform the same, why would the 401 be any different, its based off the same cup and wick principal.
before each atomizer was built slightly different, 901 had a washer in them, 510's looked one way while the 801 was bigger, so they should perform different. but all the E2's are built the same, a cup with the coil around a wick that sits int he tank inside a metal tube.
so they should all essentially perform the same.
Yeah, the first and only one I filled didn't hold quite as much as my 808 XL, even though they're the same length. Sounds about right. 3ohms is too mellow for the 401 imo.
by the way while the 650mah vgo does not stand on its end, the 1300 mah vgo does. me likey
Nice, I lay my pv on it's side all the time but that's nice to know. BTW, the 401 XL holds less I think because it's slender, haven't tore one up to see but the guts should be the same.
I love the box mods myself. I ordered one of Ken's Big Brother parallel 14500 and should have it tomorrow. 1800 mAh total in a 2AA box.
Last edited:
I got the Revision 4's (supposedly) and..I'm still getting a burnt taste after about 10 or so drags, not back to back drags, leaving time to wick. Off to cut some damn PTB
Grrrrrrrrrrrrrrrrrrrrrrrr
Grrrrrrrrrrrrrrrrrrrrrrrr
510 XL and I have no bloody idea. Got them from AwesomeVapor.com
Though I remember a post where you said the newer R4s were slightly...smaller? Or bigger? Than other revisions....
Though I remember a post where you said the newer R4s were slightly...smaller? Or bigger? Than other revisions....
- Status
Similar threads
- Locked
- Locked
