Fair enough, I guess I'm just used to getting much worse, kinda like what I got in the mail today..
RDA Geekvape Tsunami RDA
- Thread starter dansus
- Start date
- th_trl_thread_readers 0
- Status
Na, just got it this morning from Subtank Supply, a bit of QC issues with isulators and deck machining. No sign of machine oil though 
Thank!
Do you take short hard pulls running at high watt? I find it hard to pull more than a second as I typically enjoy a slow long pull with rta.
I'd rather have an atty dripping in machine oil then be all janked up with poor milling, janked threads and chards of metal visible in the post holes and spinning posi posts[emoji12]
Just picked one up off Ebay for $29. Always wanted to try a Kennedy like airflow. Got a black one.
Just picked one up off Ebay for $29. Always wanted to try a Kennedy like airflow. Got a black one.
Mine was visibly covered with oil. I have never received an atty with that much oil. Toothbrush and dish detergent took care of it in a few minutes - but yeah, I've never seen that much oil before. I thought it might have been condensation droplets but it was definitely oil.
Not a big deal - just sharing.
Not a big deal - just sharing.
I need a black one too. I might wait till my B&M gets some and throw them a sale. I want to do my part to keep them in the neighborhood.
I agree. I support 3 or 4......or 5 or 6......of my local B&Ms.
My GOON is firmly affixed on my Sig150. I have to think I can get this Tsunami to perform.
In regards to the machine oil issue, the one I got a week ago was spotless. All I did was rinse it under warm water like I do with every atty I get.
I take about 2 to 3 second pulls on average. How open is your airflow? If your airflow is closed off a decent amount it will make the vape much warmer.
Always wide open. It might be my coil, it heat up very slowly(2 pulls to get vapor and flavor) and cools even slower, dense vapor still flaots about seconds after firing.
No such problem when I use simple wires(twisted or parrelle). Though the flavor is not on the same planet.
Mine was visibly covered with oil. I have never received an atty with that much oil. Toothbrush and dish detergent took care of it in a few minutes - but yeah, I've never seen that much oil before. I thought it might have been condensation droplets but it was definitely oil.
Not a big deal - just sharing.
Same, anyways...
Is anybody elses top cap have the TIGHTEST fit in the world? I have use my big man strength to get the ....er off, it's insane. I'm going to try different o-rings but they already look pretty thin. Sometimes my battery cover on my mod will come off before the top cap.
No, my topcap was not tight. But I was one of the ones with the dripping atomizer. I wonder if it was VG and it was used on the orings so that we wouldn't harm the orings on that initial cap pull off when we opened the box. Makes you wonder...
It is tight as hell, I can't even put it back on without lubing it with a few drops of juice.
The Fat Daddy Vapes M2.5 BF pin fits, didn't even have to shorten it. Not sure if Velocity or Hobo pins would work, the Hobo 3.1 uses an M3 pin so it would not fit.
Post a pic of the bottom of the pin and how far it protrudes out of the 510 if you would.
Might have to pick one up for my tsunami!
May be a little too much for some mods but was flush on the dripbox.
- Status
Similar threads
- Locked
