2legs
On the Lemo you unscrew the bottom part , and that gives you access to the fill screw and the air control ring.
On the bottom part you can unscrew the screw and take it out ( Just did it) the opposite side to the screw on the bottom part is this metal mound and put your finger on that and hold it down when unscrewing the screw, or the screw just keeps screwing and going no where.
Other than this time I had not adjusted the 510 connection screw. On my sigelei mod it has a spring loaded pin and its been firing great.
ETA - this bottom part you unscrew doesn't hold the tank.
you have - bottom part with 510 connection screws onto the build deck bottom of which has the fill screw and air flow ring - top of build deck has thin silicon ring - then the evaporation chamber and the top part of the chamber - the tank - then the top part which on the bottom has another thin silicon ring - then the drip tip with two o-rings.
On the Lemo you unscrew the bottom part , and that gives you access to the fill screw and the air control ring.
On the bottom part you can unscrew the screw and take it out ( Just did it) the opposite side to the screw on the bottom part is this metal mound and put your finger on that and hold it down when unscrewing the screw, or the screw just keeps screwing and going no where.
Other than this time I had not adjusted the 510 connection screw. On my sigelei mod it has a spring loaded pin and its been firing great.
ETA - this bottom part you unscrew doesn't hold the tank.
you have - bottom part with 510 connection screws onto the build deck bottom of which has the fill screw and air flow ring - top of build deck has thin silicon ring - then the evaporation chamber and the top part of the chamber - the tank - then the top part which on the bottom has another thin silicon ring - then the drip tip with two o-rings.
Last edited: