this stuff wicks so good that i believe im going to drill out one of the kayfuns tonight.
drilled out the taifun to 7/64 and its awesome!
That's cool, keep me updated; I've thought of doing the same as well. Rayon really seems to take the kayfun to a whole 'nother level.
*Disclaimer: all my coils are 29ga (cuz that's all I have) and 1.65mm ID (cuz I've been brainwashed by the microcoil thread and i have an 18ga needle)
When I first started with the kayfun I was running 8 wraps, which is the minimum for a true microcoil. That was great for a while (coming from protanks for over a year straight), but soon I wanted more. So I went seven wraps at around 1.1 ohm. Vape was better, but I'd get the occasional dryhit (no matter how much cotton I used), likely because the small amount of cotton just couldn't keep up.
Next I went to dual coils, nine wraps each at .9ohms. Flavor was great, and the extra cotton i could use from x2 coils meant no dry hits. Problem was, it was extremely warm. I like a bit of warmth (which I had never had until now), but this was too much.
Then I discover this thread, found the cellucotton at Sally's, and after a couple good reports I got some as well. Because of the wicking quality, I knew I could go back to a single coil and be just fine. Decide to try a twisted coil, which would get me to a low ohm while spreading the heat out over a much larger surface area. Used the drill (dremel actually) method and it came out beautiful, like it was from the factory. I ended up at 8 wraps (I think, I'll hafta check when I break it down again) at .7-.6ohms (provari read .7 for a second then faulted, idk). This was lower than i wanted to be, because of the warmth from my dual coil .9 build, but i figured I'd try it anyways.
Stuffed it full on rayon (about 40% more than I'd use with cotton) and proceeded to vape.
O.
M.
G.
Amazing flavor, big clouds, perfect warmth (not as hot as my .9 DC build, weird). Two tanks in and never a dry hit. It's actually STILL krackling every time I hit it (always a sign for me of a new, clean coil/wick), where with cotton the krackle would stop halfway through the tank, if that (I like very sweet juice that caramelizes very quickly).
Rayon really is the solution for microcoils in a Kayfun, and helps this atty specifically a great deal.
Needless to say, I'm in vaping heaven right now and I owe it to all the participants in this thread, and especially JeremyRayon.
Thanks, guys!




Last edited: