Rebuildable Tank Atomizers - An Anthology, Pictorial, Builds and Reviews.

Status
Not open for further replies.

dems86

Vaping Master
ECF Veteran
Verified Member
Mar 3, 2014
3,441
8,146
Sacramento, CA, US
Finally! Six days in Customs
sorry.gif


2q9wfbo.png
Stupid customs
 

dems86

Vaping Master
ECF Veteran
Verified Member
Mar 3, 2014
3,441
8,146
Sacramento, CA, US
Sedge, which airflow screw for a Flash e would I want to have airflow similar to the Rose wide open? Its in the lead right now as the next one to save for. I guess I should look at the cost of those because if they're inexpensive, I could just get them all and see what I like.
It's less than 3 bucks for the 1.6mm, it comes with the other three.
 

dems86

Vaping Master
ECF Veteran
Verified Member
Mar 3, 2014
3,441
8,146
Sacramento, CA, US
The FlashEVapor (both v3 & VS) comes with 3 screws.

1.1, 1.2 (installed) and 1.4. The 1.6 is optional and is cheap. You can also run it with no screw which is about 3.0mm.

I prefer the 1.6 on the v3 and the 1.2 on the VS.
So now it's officially the 1.2 on the vs? Would you go ahead and make up your mind already
 

dems86

Vaping Master
ECF Veteran
Verified Member
Mar 3, 2014
3,441
8,146
Sacramento, CA, US
Roxy. I would suggest throwing in the 1.6mm screw in the cart. Its cheap and better to have it than not.
Yeah, for the price, worth it.

Not to mention, anyone notice how close the euro is right now to being a 1:1 with the dollar? It was 2.05 when I ordered the Calix, and last week it was 2.10...dropping like a rock the past 5 months.
 
Last edited:

roxynoodle

Unregistered Supplier
ECF Veteran
Jun 19, 2014
15,344
37,213
Ohio
Yeah, for the price, worth it.

Not to mention, anyone notice how close the euro is right now to bring a 1:1 with the dollar? It was 2.05 when I ordered the Calix, and last week it was 2.10...dropping like a rock the past 5 months.

There's that, too. The projection is that it will rise some over the next few months.
 
Status
Not open for further replies.

Users who are viewing this thread