Shinyitis Support Group

[jfcooley]

I haven't. Have this 1 squonk bottle of watermelon strawberry (little less than half) and going to switch to yours in dot

3mg won't be enough at work, but here at home will be fine.

Wait, did drip Vanilla almond milk and was good. Nice with coffee.

Luxotic has Choc caramel coffee.
Dot has Gallagher (water/straw) (6mg)
Therion currently has Legendary.

 

[whodat2112]

Did I send you CC's Peanut Butter and Chocolate?

I'm currently hooked on it

 

[jfcooley]

No, I looked.
Sounds good. I surprisingly like the chocolate.

 

[whodat2112]

Damn, next time.

 

[Skunk!]

Stay Shiny!

 

[jfcooley]

I'd read a little of the Entheon thread here in ECF and had an idea of what build I'd put in it.
3mm ID .2 fused Clapton, sort of high on the deck, aiming AF at bottom similar to how I do the wasp & B2K.

I'm finding flavor to be on par with both of those, perhaps a little smoother and maybe a hair muted. I'd be picky to say that though.

Building on it is a bit challenging similar to getting the Wasp coils in their posts. I may have used just a bit more cotton than I should have. Draw on that tiny tip isn't as restricted as I would have thought. I think it's 810 but feels smaller.

The clear cap is...ok. it's similar to the stock stainless cap but amazingly tight. AF spins just fine, but it is tough to get on.

Overall will be fine. Without the authentic it's hard to tell just how close a clone it is. However unless the authentic is measurably better with flavor than I see little reason to buy it, for me that is.

Just my 2¢

 

[TrollDragon]

No. We are still talking about USPS...View attachment 722279

You have the leads under the wrong side of the clamps. If you have the coil wound the wrong way, you can always flip the clamps around so the wire goes under the non stepped section.

 

[jfcooley]

You have the leads under the wrong side of the clamps. If you have the coil wound the wrong way, you can always flip the clamps around so the wire goes under the non stepped section.

Funny you mention that. Took a good look at it after psoting that and realized same thing.

Swapped clamp sides, lost a screw in the process. I wasn't 100% sure I'd done it wrong, sincere thanks for pointing it out.

 

[Coastal Cowboy]

You have the leads under the wrong side of the clamps. If you have the coil wound the wrong way, you can always flip the clamps around so the wire goes under the non stepped section.

He's just being a good electrician and making sure the leads go on the left.

That would be my story, anyway.

 

[TrollDragon]

He's just being a good electrician and making sure the leads go on the left.

That would be my story, anyway.

Good Answer!
Doesn't apply to clamps though.

I hated the Kayfun screw heads, so I cut wire channels to assist in trapping.

 

[whodat2112]

I used to use Kayfuns (clones)

Probably have 5 or 6 around here somewhere.

If anyone wants them, no charge of course.

I used to like them until I stared direct lung vaping.

 

[jfcooley]

Truth in advertising....FT never ceases to amuse me.

 

[whodat2112]

 

[whodat2112]

Kayfuns are spoken for.

 

[Skunk!]

And, any comment that begins with "in all due respect" is most likely only leading to one place...

Usually sentences that begin "With all due respect" end with something pretty disrespectful...

 

[jfcooley]

With all due respect, I seldom show respect.

 

[the wind]

Truth in advertising....FT never ceases to amuse me.View attachment 722299

good find. this one could be true too.

 

[jfcooley]

Any active FT codes other than MAP?

 

[Coastal Cowboy]

Any active FT codes other than MAP?

 

[the wind]

happy new year