Ordered some 1.5mmx0.2mm (1/16"x1/64") flat wire
That's some wide wire, I have been using .8 x .3 ss.
Bet the resistance is lowwwww.
I'm planning some 4.5mm-5mm ID builds so it won't be that low. Should land between .25Ω and .3Ω (single coil).
I have a couple valerian tanks an absolutely love them... been on the same coil for over two weeks.. Good luck and happy shopping
Vaping on one right now !
Revvo would be the tank I vaped if I did not build my own coils. The Alpine is almost identical, only real difference is that you can take off the top cap and replace it allowing you to change drip tips to a standard 810 on the Alpine.
So Meg, my cousin, wants a sidebar firing device (dual 18650). She has the Eleaf 100w. The only two I can find I would recommend is the Aspire Speeder and the Wismec Ravage. Any ideas for others?
I don't know of any, but people seem pretty happy with the aspire speeder. Honestly, that's a mod that I still don't know why I don't have one. LOL.
Anna
Anna
I've only had a mild curiosity about the Revvo coils. Not crazy about tanks I have to tip. One of the reasons I don't play with rdtas.
Wismec has some more of those like the sinuous p228 or the sinuous fj200. They're pretty similar to the ravage in terms of looks.
Smok and internal battery are off the table. I take care of Meg's vape and won't recommend finicky. Her hands are worse than mine and sidebar works for her plus I just stocked her up on 18650s. She is moderately hard on her gear.
@whodat2112 hope you feeling better.time for your normal
I am feeling fine, just tired last night. Think I was in bed for 7 p.m.
I don't stir the pot, do I ?
You are not missing much. They take quite a bit of power, are meh for flavor and drink the joose likes it free.
You really don't have to do the "Genny Tilt", normal vaping will keep the wick saturated. The "Genny Tilt" was a way to prevent dry hits back in the day for those who couldn't actually build mesh properly.
Last edited:
abnormal and horrible weather stopped me getting to the shops...18" drifts currently...but i have litres of DIY to see me through...now, if only i had a still...
I am thinking about buying this:
Reuleaux RX2 20700 TC Mod - Jaybo & Wismec I Vape Hardware I Breazy.com
Anyone have one?
Any reasons as to yea or nay?
Reuleaux RX2 20700 TC Mod - Jaybo & Wismec I Vape Hardware I Breazy.com
Anyone have one?
Any reasons as to yea or nay?
I sure love mine... was my first mod i purchased to help quitting the cigs...The original tank had nothing but problems with leaks over and over again. But since putting the Revvo on it, it has become a favorite to use once more, a bit slow to fire but otherwise its a nice smaller mod.
Wismec did have problems with their design of the battery door and all the contacts mounted to it. You may have to get your fingers dirty and tweak that connection plate and spring loaded pin after a while to make the mod work properly again. Often tightening all involved screws or bending the little contact tongue that touches the spring loaded pin does the trick.
Similar threads
- Locked
