Well my first build of my supreme V2 didn't go too well. I obviously didn't use enough wick. It didn't leak exactly but it did flood the chamber.
I decided to go with the included post less deck and used a 3.5 Id single coil so that the wick would be nice and thick. I covered the wicking chambers pretty well but obviously not well enough. I do have the single coil deck but decided to go with the standard one after reading the comments from @TrollDragon. The post less deck is single coil really anyway. You could fit a dual set up in there but it would be very tight. Looks like I need to get the velocity deck.
I'll try again when I'm back at home again, I'll crack it with a bit more experimentation. I managed to get a few good pulls on it as it gradually flooded and the flavour and vape production was good if a bit airy. Closing down the juice flow control partially didn't help either.
Any ideas welcome.....??
I decided to go with the included post less deck and used a 3.5 Id single coil so that the wick would be nice and thick. I covered the wicking chambers pretty well but obviously not well enough. I do have the single coil deck but decided to go with the standard one after reading the comments from @TrollDragon. The post less deck is single coil really anyway. You could fit a dual set up in there but it would be very tight. Looks like I need to get the velocity deck.
I'll try again when I'm back at home again, I'll crack it with a bit more experimentation. I managed to get a few good pulls on it as it gradually flooded and the flavour and vape production was good if a bit airy. Closing down the juice flow control partially didn't help either.
Any ideas welcome.....??