Sneak Peak: The Hybrid 306/510 Atomizer

Status
Not open for further replies.

Katdarling

I'm still here on ECF... sort of. ;)
Supporting Member
ECF Veteran
Verified Member
Jan 25, 2011
32,581
167,741
Utopia
Am I the only one who cleaned my atty? If you have, please let us know your experiences after cleaning it. I think my imagination might be getting the better of me, but the one that I've not cleaned seems to taste better than the one I have.

Then again I think that's all your fault, you non-atty-cleaners, you! ;)
 

tierrataz

Vaping Master
ECF Veteran
Verified Member
Mar 2, 2011
5,086
2,369
soCal
All 3 I am using right now have been cleaned. 2 were bought off the classys and I'm not sure how they were cleaned but based on performance and what I was told, they didn't get broken in. Now they are :) The one I cleaned by just boiling water soaks (2), came back quickly once the mesh was saturated. They are all producing a wonderful vape.

On dark juice, I think Mangus asked?? I ran a 3ml sampler of dark capp (juice is almost black) through today....dumb! The draw did start to tighten up and I will be cleaning it tomorrow. I don't normally vape juice you can't see easily through. Halo is my #1 choice.
 

violetvoo

Vaping Master
ECF Veteran
Verified Member
Apr 22, 2009
7,240
19,644
Down the rabbit hole..
This one is keeping me good company still, getting the hand of it, liking the flavor now. Pull style adjusting slowly. Need to ohm it out but I think AG said they're all, unless defective, within +-0.1ohm. Trying some new Copper Creek stuff and it's working nicely. Although this bit about not cleaning is not working for me, I'm on 60/40 PG/VG... I'm assuming at least some people are using dark and higher VG nicquids, no? -Magnus

I'm vaping Copper Creek in the standard and Bobas in a bf hybrid not cleaning them works great...I have tribeca in another bf one...but then
I rarely clean attys..:)
 

MagnusEunson

Bearded Super Villain
ECF Veteran
Verified Member
Apr 30, 2011
4,448
4,789
Behind you
Yeah, I've got one 100% VG (Gorilla Juice) and it's NOT working for me after a few hours. 4.4v/1.8ohm. I drop that to 3.9v/1.8ohm and it's not much better. Starts dropping off right-quick. And a quick flush and simple clean and I'm back on track for a half-day or so. Loving the performance but this not cleaning bit is not the same I'm experiencing. -Magnus
 

Angler

Senior Member
ECF Veteran
Jan 27, 2011
266
81
69
Ausable River
I've been on my original 1.5 bottom feeder except for a couple days on one of my new ones (because I broke it) and a couple of days off and on with a Cisco since July 18th vaping nothing but AVE Havana Gold without cleaning. It vapes like it did from the time I broke it in which was only a half day. I never had much luck cleaning an atomizer anyway. I used to clean them but it seems that after cleaning I got an unwanted taste from them until I used them for awhile, if I was lucky, if not they just were not any good no matter how much I used them. I can't tell that anything has changed with mine and the flavor especially is still top shelf.
I broke one of my new ones because I had this bright idea to adjust it with a screwdriver by turning the center connection. I couldn't push it up any further so I thought maybe I could screw it up there more but I suppose it must have broke the coil when I turned it. I've never tried doing that to an atomizer before so I gave it a try. Oh, it does'nt work, I mean, it won't go up any higher by turning it.lol When I checked it with my multi-meter it didn't measure anything.
I'm going to order a standard Hybrid or two because I'm thinking they might be better for a Woodvil because they're built like a regular atomizer and I won't have to worry about over-tightening it. I just hope they vape as well as the bottom feeder.
 

karmyn

Full Member
Nov 27, 2008
29
5
Dallas TX
I just ordered them on Thursday and I got them on Saturday. COV is quick good service.
I have been vaping on this for a few hours - not enough time for a honest review but I love it so far. I blew out the end to get out the primer and I get a pure flavor from my mango home made juice and great TH. I'm using them with my SD and a adapter and it works great.

I have ordered a No Ego from jazzpipes - that hasn't arrived yet. He is not as quick as COV- my credit card still has the charge peinding. :( The No Ego has a 510 connection with a 14500 battery - 3.7 V. That is why I chose a 1.5 Hybrid. I can't wait to try out that combination. The Hybrid does use some juice- gotta keep it wet. But that is the price you pay for performance.
I'm loving this so far I hope it will last longer than my LR 901 attys:2cool: and still have the same performance as I'm getting now. I will do another review after a couple of weeks and let you know how it holds up.
 

MiMoSeTH

Senior Member
ECF Veteran
Verified Member
Jul 11, 2011
163
92
Spain
For those that have tried both the standard Hybrid and 306 attys for dripping, how does it compare to a 306 LR?

I'm really new to dripping and i only got 2 Joye 306 LR attys that, for some reason, give me hardly any flavor at all. I dewicked both and debridged one of them and still nothing, hardly any flavor. Wondering if i got 2 duds or what...

Since i already tried the Hybrid bottom feeder attys and perform really well, i was considering buying the standard hybrid for dripping and tasting my DIY juices. Would it be worth it or should i try to get maybe some Cisco 306 LR or something?
 
Status
Not open for further replies.

Users who are viewing this thread