Not if you use a hacksaw! Oh, you mean to shorten it and still have it work...And a bit tougher to shorten!!
Tootle Puffers, Redux (The Sequel)
- Thread starter Katdarling
- Start date
- th_trl_thread_readers 0
- Status
Save some time - they do have it in stainless 
Just to touch on these CF4 mods again, especially after they have been etched, it really is a great idea to buy a clear transparent wrap for them from jwraps, protects everything for as long as the wrap lasts, feels good in the hand too, more grippy..
I haven't seen any wraps that were truly transparent. Mostly I don't care for the feel of wraps; if there any anything granular on the counter when I set them down (salt, sugar, etc), it sticks to those silicone wraps, feels nasty.
Andria
Can use a Kick in it with an 18500? I dont remember if that had a VV Board in it or not?
Last edited:
If it's an 18650 tube, it's already at the length you need to use an 18500+Kick.
Andria
Duh, Im not thinking straight, im doing a heat treatment in an apartment... Thats what 130 degrees gets me lol
I need a new Job... Need to go start getting more (Really need more College) Certificates for Networking & Security... Much easier... lol
Another good trick, RE: 18500's -- if you use a Kick ring from a 22mm mod (a Chi You kick ring is the kind I use) on a Vamo, you can use an 18500 and not have the thing be so long it's half of a pogo stick.
Andria
Andria
A little electronic module you drop into a mech so you can have a regulated vape (same from first hit to last).
Andria
I have 8 or 10 regulated mods; I also have 2 mechs, for vapocalypse prep, but I always want a regulated vape, so I stocked up on Kicks too, to put in those mechs, should I ever be down to nothing but mechs and no way to buy new electronic mods.
Andria
I wouldn't say I'm particularly worried; given the opportunity to make a lot of money on vapers, I think the gov't is far more interested in taxing us than banning us -- what worries me more is that regulated mods might go from $30-$100 to something like $150-$500, due to taxes -- which would put them far beyond my reach. Ditto that for nicotine, which is why I have about 5 yrs' worth in my freezer.
I see the writing on the wall; it might turn out to be nothing but graffiti, but then again... "the words of the prophets are written on the studio walls" as some very good songwriters once said.
Andria
Andria, I was just having a silly moment. I was imagining the sliding panel in the wall, the trap door under the rug, or the special cabs in the cities.
Not only that, but there will always be tinkers who can make a PV out of a lobster and a stick.
On edit: I think I'm going to make a mech mod tonight out of a toilet paper tube, aluminum foil and wire. And a battery. One that won't make too much of a mess when it goes "BOOM!!!"
On edit: I think I'm going to make a mech mod tonight out of a toilet paper tube, aluminum foil and wire. And a battery. One that won't make too much of a mess when it goes "BOOM!!!"
Last edited by a moderator:
I was thinking that as I was removing the finish with lacquer thinner and sandpaper. But the only reason I did that was because the finish on the original was so bad, you couldn't do anything without scratching it. How bad the finish was is evidenced by the fact that it took me all of 5 minutes to remove it completely.Save some time - they do have it in stainless
That said, I'm still deciding whether to buy 1, 2, or 3 more of them. In stainless. If I buy one, it will be to make a 18500 version. If I buy two, it will be to make nunchaku. If I buy three, then all bets are off.
I'd suspect NOT, since it already has electronic regulation.
- Status
Similar threads
