Are you done stocking up?

[bnrkwest]

One thing about all these pods is I recommend taking the pod off when not vaping so you don't risk leaking ruining your battery or electronics. Just better safe than sorry. I do the same with tanks anyway.

 

[bnrkwest]

That very odd. You shouldn't need a 25A battery to vape on a 1 ohm coil.

I've had this "weak battery" problem happen to me when I use old batteries at too high a wattage. The battery sag is too much and therefore the voltage drops below the mod's low voltage cut-off, causing weak batter and other errors.

Makes me think that the pod system is defective or highly inefficient, causing major battery voltage sag or something, or your battery's health is shot (high internal resistance will cause major sag).

That was recommended on the OXVA tutorial. Just thought I'd mention it. I took a batt out of the Jac to use and it isn't new but had full charge and did fine. The OXVA goes up to 60 watts, so maybe just needed at higher watts? I have mine set on 10 W with the 1.0 coil

 

[YoursTruli]

One thing about all these pods is I recommend taking the pod off when not vaping so you don't risk leaking ruining your battery or electronics. Just better safe than sorry. I do the same with tanks anyway.

I only have one pod system, no leaking issues, but where would a pod leak from the bottom?

 

[UncLeJunkLe]

That recommended on the OXVA tutorial. Just thought I'd mention it. I took a batt out of the Jac to use and it isn't new but had full charge and did fine. The OXVA goes up to 60 watts, so maybe just needed at higher watts? I have mine set on 10 W with the 1.0 coil

At 10W, the PCB would have to operate at or below 13% efficiency in order to require a 25A battery.

 

[UncLeJunkLe]

I only have one pod system, no leaking issues, but where would a pod leak from the bottom?

The fill port (if on bottom) or at the electrical contacts. I'ave seen pod system reviews where the juice leaks though the contacts. Or anywhere there is a seam or joint, really.

 

[Haktuspit]

10% off 21700 batteries at IMR batteries. That's all I really have to contribute for deals these days I turned all my e-cig emails off except IMR.

10% Savings Just for You

 

[borno]

I only have one pod system, no leaking issues, but where would a pod leak from the bottom?

Sometimes a coil will leak through where the coil wires go through the rubber in the bottom of the coil

 

[Tor R]

Yep, almost done to stock up, need a few attys, a few mods, and a bunch of ingredients + nic.
Hopefully I'll be done before the Arctic ice is done melted.

 

[UncLeJunkLe]

Yep, almost done to stock up, need a few attys, a few mods, and a bunch of ingredients + nic.
Hopefully I'll be done before the Arctic ice is done melted.

Are you Norwegian vapers fixing on a vapocalypse?

 

[bnrkwest]

I only have one pod system, no leaking issues, but where would a pod leak from the bottom?

Coil area leak is where the Vinci has a problem. I love the Vinci but the leaks are a problem if you do not take the pod off and check it regularly. If I take several draws the then take it off, no problem.

 

[Tor R]

Are you Norwegian vapers fixing on a vapocalypse?

if it's the calculator to vapocslypse, then i'm innocent.
What can save my plan is if the whole globe phases out the internal combustion engine and runs electrically, it gives me time to build up my stock.

 

[bnrkwest]

I tried the OXVA RDTA and it works great! So handy to have that on a pod. For a do it all device OXVA delivers. If you like a 510 drip tip, you need a 810 adapter. It vapes great. The wick channels are fairly small, I may need to thin my tails more. Using SS .88 coil and rayon. Great flavor!

 

[bnrkwest]

Good price on the Voopoo Vinci pod with internal batt, comes with 5 coils. You can get the PnP RBA for this one thru Sourcemore or SMRT RBA. I like the Vinci, just take the pods off so they don't leak, use high VG juice too.
Vinci 40W Pod System - Voopoo

 

[Z-Lee]

10% off 21700 batteries at IMR batteries. That's all I really have to contribute for deals these days I turned all my e-cig emails off except IMR.

10% Savings Just for You

I've been hovering on this page for days waiting for their Molicel stock to refill. Big oof.

 

[Oregon Linda]

I've been hovering on this page for days waiting for their Molicel stock to refill. Big oof.

Are you waiting for the P42s? Every store I've checked seems to be out, so I hope they're not gone for good. They're great batteries. Even the Samsung 40Ts seem to be out everywhere as well.

 

[Z-Lee]

Are you waiting for the P42s? Every store I've checked seems to be out, so I hope they're not gone for good. They're great batteries. Even the Samsung 40Ts seem to be out everywhere as well.

Indeed. They just took the 40T's off the line at IMR - I had 6 of them in my cart waiting to see if the Molicels would come back sometime soon. I no longer see 40T's and they were stripped from my cart.

 

[Z-Lee]

 

[Z-Lee]

I've been considering going the Sanyo NCR2070C 30A 3475mAh route, but they seem quite overpriced with the shortage that we appear to be facing.

 

[Haktuspit]

This looks like a fun thread if you're looking to win some vape arguments. I haven't read all, or reviewed any for accuracy.

 

[DeloresRose]

My favorite is the Thelema pod but haven’t seen a 510 adapter for it yet.

I love the Thelema. Have you tried the rba for it? Looking for tips. I built it twice but I’m less than impressed with my results. I can usually do those tiny RBAs okay not sure what my problem is with this one.