Authentic Svoemesto Kayfun Prime
- Thread starter Bronze
- Start date
- th_trl_thread_readers 0
- Status
If you figure it out, remember what it was because there are some who really like it tighter....did you take out the entire airflow pin, the tube under the hex plate?
Sent from my SCH-I545 using Tapatalk
I believe so, the fix was so obvious when pointed out. I wish that I had not embarrassed myself so publicly, good thing there is some anonymity on a forum.
If you think you're the only one to miss that, think again. No reason whatsoever to be embarrassed.
Talk about embarrassing, I was rewicking once and after I glew (I know that's not a word, but I like it better then glowed) a coil (I was in a little hurry) I went to blow on it to cool it down, but got to close and burnt my darn lip...you could literally see coil lines on my lip
Sent from my SCH-I545 using Tapatalk
Sent from my SCH-I545 using Tapatalk
Hey folks - I am having an issue with my prime after putting some miles on it. I am wondering if anyone else has experienced this. After a week or two on a coil I start to get fluctuating resistance. My freshly built coils come out right under 1 ohm (6 wraps kanthal, 2.0 ID) and the resistance is stable for several days. The fluctuations take it up to 1.4, 1.5 or higher. Once that starts happening it ping pongs back and forth between the original resistance and the high resistance. Getting the coil hot from use seems to drop it back down. I haven't had this problem on other atomizers, but I took a break from building for a while so maybe I'm just sloppy now. Any feedback on what may be going on in there would be greatly appreciated. Thanks!
Check the bottom pin/screw on the 510 connection. Litter bugger likes to loosen up on it's own. First and easiest thing you can check.
Yep its usually the pin on bottom or possibly a loose connection. You can also pull out the 510 screw and plate and check the base of tube. This af tube tightens into the build deck and if it's loose, you will have issues
Sent from my SCH-I545 using Tapatalk
Sent from my SCH-I545 using Tapatalk
I concur with the others regarding the center pin. If that fails just take the whole thing apart. Clean it and put it back together.
Thanks folks. This sounds like a great place to start. Appreciate the quick feedback!
Let us know how it works out.
This will, sometime, help all of us (well, maybe not all but certainly one of us who is nameless).
This problem has been run into before by many of us. That center pin comes loose over time and wigs out the atomizer...especially with TC vapers. Doesn't hurt to give that center pin a little cinch every few months. In fact, I'm going to do mine now.
have you maybe noticed the KP draining battery faster than other RTAs?(same 1.5ohm @12w)
maybe it's just device related for my part.
maybe it's just device related for my part.
I personally havent, but it's interesting. I never though or ever heard comparisons between different tanks regarding battery draining, at least not with the same exact build and power
Sent from my SCH-I545 using Tapatalk
Just found out I actually forgot to wash the Prime when I got it about a week ago. Should I still do that?
Well, it couldn't hurt. From what I've read though the authentic Primes aren't arriving liberally covered with machine oil, and if you've been vaping it for a while and not noticing any problems/taste issues, I'd imagine it could probably wait until your next re-wick or whatever. I mean... do what you are comfortable with but if you aren't getting horrible tastes/smells etc., I'm not sure what much it would do for you at this point.
Anna
Anna
- Status
