Back and still frustrated - yay

Status
Not open for further replies.

ranjen617

Senior Member
ECF Veteran
Oct 28, 2014
183
409
53
Somewhere in mid - AL, USA
I've had nothing but issues with my Zeus Dual. It normally just sits. You can try to place around a 0.4 ohm coil or setup in it, making sure you wick it properly as the atty is finicky. I don't get the best flavor from mine and chain vaping is not its strong point even with lower builds. I understand it's not affordable to just buy another atty after just buying this one but my Pyro 2 is certainly the difference between night and day even if it's a Rdta and the tank is only 4ml. Hope this helps and I'll try to build on mine this weekend to see what can work with low and higher builds. Try to thin your cotton just a tad if it's burning a tad to start with. I have my build on a .48 right now and it keeps up decently but isn't the best atty I have. :cool:;)
 
  • Like
Reactions: stols001

ranjen617

Senior Member
ECF Veteran
Oct 28, 2014
183
409
53
Somewhere in mid - AL, USA
Did you or do you have these coils on the build? I went into my atty box and found the ones that were sent for it. These coils are more than sufficient to be able to run a good while longer. Not sure what your friend put in yours but see if they look like this. ...:)
20190125_030225.jpg
20190125_030220.jpg
 

Attachments

  • 20190125_030211.jpg
    20190125_030211.jpg
    912.7 KB · Views: 3
  • Like
Reactions: stols001

ranjen617

Senior Member
ECF Veteran
Oct 28, 2014
183
409
53
Somewhere in mid - AL, USA
@PatVapes On your other post I've basically addressed as well as others here on a few issues.
Did you ever check to see if those were the coils that were included in the box. They are very good coils as well.

Again, try to wick it using less cotton and fill the atty up before it gets low. One third is my lowest cut off. :)
 
  • Like
Reactions: stols001
Status
Not open for further replies.

Users who are viewing this thread