So I happen to have a SpheroidV2 and since it is fed from the top with sera wool, and it has a bottom/center air hole, and the stove pipe center up towards the mouth piece, I think it may be an excellent candidate for this build with a single "dragon" coil, vice using the silica in the center like I have been doing with it since I got it. Just not sure if I want a vertical coil with air coming straight through it our a horizontal and trying to figure that all out. This would turn it into basically a big cartomizer like the drawing posted way early in your thread, but with a micro/nano coil. If it works well, will post up the build. 
Might want to try this... http://www.e-cigarette-forum.com/fo...uild-genesis-type-atomizers.html#post10863955TEO, first off props man! The concept is so simple, and simple is usually the most effective.
So I don't have any drippers. I tried this on one of my gennies, and am impressed. Thing is, I am trying to figure a way to wick efficiently. I get I can just tilt to wet the cotton from my tank or drip
Thanks for sharing your builds!
try to center your coil or at least in between your positive/negative post and it'll be perfectMy setup on a Nimbus clone, single coil, 25AWG, 6 wraps on a paperclip giving me 0.5ohns...tremendous clouds...
.628Ω 7/8 wraps 28g nichrome on my small paperclip jig
soaked and vape dried
my ohm checker reads it at .628Ω it read up to the sub 100th, it automatically drops the 0. when it reads sub ohm
Well I can tell you that 32g was more or less a wide open carto (awesome) while 28g makes some awesome fat clouds and I haven't broken 2 ohms yet. They took me around 20-30 minutes each to build. I've had cartos last me 150ml+ and thats my aim. I'm pretty sure they use a smaller gauge wire than 32.
