Do me a favor. Pull that filler ring out of there and use the middle ring flat side down. I have a hunch it might help.
E2 Cartomizer Technical Discussion
- Thread starter zoiDman
- Start date
- th_trl_thread_readers 0
- Status
Do me a favor. Pull that filler ring out of there and use the middle ring flat side down. I have a hunch it might help.
Hmm I was hoping the new ones would work better at 3.7v. Sounds like another job for PTB.
They do vape better, I'm working on the 808d r4 on the vgo, what happened is that they didn't put the coil loops in the right place.
You wouldn't want to vape an ecig that has a heat sink attached to the coil right?
Well that's what they did with the ceramic cup and their misplacing the coil loops!
Last edited:
BR is insane , i think he needs his meds, somebody get the nurse, the r4 3.0 at 3.7 rocks.
That was with my favorite juice, which is completely ruined at 4.2 volts. My secondary juice is fine at 3.7 volts.
I'm looking at the two pieces here side-by-side (from an older revision). To the naked eye it looks like the middle ring is slightly larger in diameter and has a slightly smaller center hole (plus, it has no fill holes cut through it).
Who told you that I am vaping an R4? I buy you books and buy you books and all you do is eat the cover off.
Maybe that's how they get the milk out.
Maybe cause the U.S. cows have silicone implants that clog up the holes
Hey now, be nice to me!
Be nice to you? Hell, you're one of ours now... we love ya!
Well I'm married and in NC and your hubby shoots things in the dark, so let's go with "sweet".
Yeah... and I sawee
BanjoMan I just topped it off again, and found a leak again, but I need to remember that mark I saw on the cup, could it be fractured I wonder
Were you getting the "slurpies" while vaping, or just notice a little juice inside when you went to refill? There's a difference...
Probably the first answer,
what happened is I topped it off, put it back together and then it wouldn't breathe easily, so I took it off the battery and found a puddle in the vgo thread part
I cleaned it and blew the stem clean, it's doing fine again
what happened is I topped it off, put it back together and then it wouldn't breathe easily, so I took it off the battery and found a puddle in the vgo thread part
I cleaned it and blew the stem clean, it's doing fine again
Well, I got some of the r4's in the mail today from CoV. I am using them on an eGo, without any of the inner rings/plugs. Earlier I found that using the rings/plugs caused wicking issues. Now I am thinking that it is probably not due to the rings/plugs, but because these are not the 3.0 or 3.2's that badkolo has been sending out (if I remember correctly, CoV is sending out 2.6 or something like that).
If I hit it quickly one after another, it is definitely not wicking fast enough. However, if I wait for a minute or two between hits, there are no dry spots and it tastes nice and fresh.
Tomorrow I will try it again with one of the inner rings/plugs (or maybe both). I did find that the wick was really scrunched down in the slots, so I fluffed them up and that seemed to help, also.
If I hit it quickly one after another, it is definitely not wicking fast enough. However, if I wait for a minute or two between hits, there are no dry spots and it tastes nice and fresh.
Tomorrow I will try it again with one of the inner rings/plugs (or maybe both). I did find that the wick was really scrunched down in the slots, so I fluffed them up and that seemed to help, also.
- Status
Similar threads
- Locked
- Locked
