Older Folks and Vaping Front Porch - Part Three

Status
Not open for further replies.

mekc57

Super Member
ECF Veteran
Verified Member
Oct 27, 2013
530
2,748
Oregon
New toy!
image.jpg
The Porvari mini is just for a size comparison!
dna 40 Vaper Flask. Working great so far! Used my K4 on it yesterday and wiped up a nickel build, single coil, on my Patriot today and the temperature control is working just fine! 28g nickel, 12 wraps, 2.4mm .11 ohms 450 deg, 28.5 watts:vapor:
 

PapaSloth

Ultra Member
ECF Veteran
Verified Member
Aug 16, 2014
1,634
10,080
Portland, OR, USA

horton

ECF Guru
ECF Veteran
Verified Member
Aug 11, 2010
21,653
1,692
Left Side of Florida
OK make up my mind for me someone. Wait for the 22mm Kanger subtank or get Lemo's. The sub has a pretty small build deck but they are a lot heavier duty. The Lemos have been around for awhile and a lot of loyal followers.

Lemo!!!! Get one to fiddle with but I'd be willing to bet you will go back for more like I have. I was a little leery of them at first and honestly it was because of the price, but the Lemo is a dandy atomizer and it vapes up a storm. No complaints about quality. I did get an extra glass just in case of a disaster -- my whole house is ceramic tile. I also like the ~5ml juice capacity. It is not finicky to coil and wick -- I find it to be as easy as the KFL's. Just my :2c:
 

2legsshrt

Resting In Peace
ECF Veteran
Oct 19, 2009
7,162
107,789
75
Spokane,WA
Lemo!!!! Get one to fiddle with but I'd be willing to bet you will go back for more like I have. I was a little leery of them at first and honestly it was because of the price, but the Lemo is a dandy atomizer and it vapes up a storm. No complaints about quality. I did get an extra glass just in case of a disaster -- my whole house is ceramic tile. I also like the ~5ml juice capacity. It is not finicky to coil and wick -- I find it to be as easy as the KFL's. Just my :2c:

Well that sounds good. I was kinda leaning that way because I plan on getting 2 and using them with NI200 coils. They are a little bigger then the microcoils cause they need to be spaced and the Kanger doesn't have a lot. I wonder how stable they are with resistance I think pretty good. Do they have to be drained to work on the coil?
 

horton

ECF Guru
ECF Veteran
Verified Member
Aug 11, 2010
21,653
1,692
Left Side of Florida
I haven't had any issues with the resistance fluctuating. Make sure the screws holding the wire are cinched down nice and snug and you will be fine. Goes without saying to make sure the center post is nice and tight as well. You will have to drain it to change wicks, but I've never found that to be a huge issue. If I'm trying a new coil / wick I don't fill to capacity and then use a syringe to drain it pretty well dry.
For me they are the best bang for the buck out there in vapeland.
 

FlamingoTutu

ECF Guru
ECF Veteran
Aug 5, 2013
11,129
1
57,501
In the Mountains
Hi Matt,

I was going off of this line:

5-260W / 2-8.4V / 1200mAh Li-Po / US plug charger

I'm not sure what a 1200mm battery would even be, since that's 4 feet long, even though it does have this line elsewhere in the page:

MAXIMUM SUPPORTED BATTERY LENGTH 1200 mm

Damn, that's a long battery. I guess you'd need that for a mod that runs at 280W.

Four feet, eh? If you put a proportional topper on it I'd need to haul around a step stool too because it would be taller than me. :glare:
 

DavidOck

ECF Guru
Supporting Member
ECF Veteran
Jan 3, 2013
21,239
178,485
Halfway to Paradise, WA
I DID IT!!!!
28g Kanthal, 16g needle, 12 wraps, 1.7ohm torched & squeezed, wicked & vaped. Whadayathink?

VERY Nice!! What kind of invisible wick is in it? Heck, I've never seen invisible wick... :laugh:

OK make up my mind for me someone. Wait for the 22mm Kanger subtank or get Lemo's. The sub has a pretty small build deck but they are a lot heavier duty. The Lemos have been around for awhile and a lot of loyal followers.

C'mon, we know you're going to get both.

Lemo!!!! Get one to fiddle with but I'd be willing to bet you will go back for more like I have. I was a little leery of them at first and honestly it was because of the price, but the Lemo is a dandy atomizer and it vapes up a storm. No complaints about quality. I did get an extra glass just in case of a disaster -- my whole house is ceramic tile. I also like the ~5ml juice capacity. It is not finicky to coil and wick -- I find it to be as easy as the KFL's. Just my :2c:

Agreed. I have a handful of different KF models, love 'em all, and one Lemo. So far :) And maybe easier to work on due to the difference in design.

Four feet, eh? If you put a proportional topper on it I'd need to haul around a step stool too because it would be taller than me. :glare:

That's what they make swivel tips for (read that carefully :laugh: )
 

FlamingoTutu

ECF Guru
ECF Veteran
Aug 5, 2013
11,129
1
57,501
In the Mountains
I DID IT!!!!
28g Kanthal, 16g needle, 12 wraps, 1.7ohm torched & squeezed, wicked & vaped. Whadayathink?

View attachment 403845
View attachment 403846

Go Kenna! :toast:


Today’s headline. :facepalm:

Dangers of e-cigarettes when not used correctly - My News 4 - KRNV, Reno, NV


LEGS, here is a story you might like along with you others from Washington.

Want Bad Tax Policy? Here's A Blueprint - Forbes


FWIW, quacks just started offering base juice. 30ml for$12. Just add nic and VG. Makes it really reasonable.

https://www.quacksjuicefactory.com/category-s/1824.htm

They recommend 25% flavoring? Maybe it comes with flavor eraser in it. :p


New toy!
View attachment 403876
The Porvari mini is just for a size comparison!
DNA 40 Vaper Flask. Working great so far! Used my K4 on it yesterday and wiped up a nickel build, single coil, on my Patriot today and the temperature control is working just fine! 28g nickel, 12 wraps, 2.4mm .11 ohms 450 deg, 28.5 watts:vapor:


I’m glad you’re liking it. I’d have to use two paws to vape that. :glare:
 
Status
Not open for further replies.

Users who are viewing this thread