- Status
Tried a trico on the kayfun lite+. Wasn't too impressed, think my nanos were too small. Good flavor just not much vapor.
Attachments
Last edited:
There is no wick going around the bigger coil. Try wraping the wick around it. It should have wick on all sides.
If your burning your cotton wick is not sticking fast enough, I run vertical coils on gennys at. 4 ohm and have no problem with wicking and burn 15ml of sticky juice without replacing my wicks. Post some pics and I'll try to figure out what's wrong with your cotton setup, well get it working so you can enjoy cotton too.
First quickie setup like this... There's a ss cable u wick underneath the cotton ball... It's kind guess...
OK... I like it a little better now. . .
Sent from my Transformer TF101 using Tapatalk
Sent from my Transformer TF101 using Tapatalk
I don't want to get into any kind of pissing match here... If you want an RTA you might want to look into a Killer 705 or a Sophia....
We don't want to be picky in this thread. The last one that started the whole "RDA / RTA / RDA / C3PO" argument got locked out of indignity to others so let's stay on track here. This thread is too valuable to be lost to that nonsense.
I have an ihybrid so what category would that fall in?
Sent from my HTCONE using Tapatalk
Tried a trico on the kayfun lite+. Wasn't too impressed, think my nanos were too small. Good flavor just not much vapor.
i'm confused here...
Kayfun Lite+
i'm confused here...
Oops, I was very tired; SQuape. Nice lookin out
Sent from my iPhone using Tapatalk
i've never seen the deck of a Squape, so i was outright confused... still half way through my coffee...
Funny thing is that when I made that coil I intended to put it on the kfl+. But since tank was full I guess I put it on SQuape since I could pull tank off the deck while full. Then I forgot to wrap outside of large coil and wondered why it wasn't producing much vapor... Oh well, can't always bat 1.000.
Sent from my iPhone using Tapatalk
I don't have any pics. But I did just rebuild my taifun gt last night with cotton with no problems but it still don't taste as good as mesh to me. But I'm gonna use it for a few days and c where it goes
.25 twisted with cotton. I folded over the longer side and cut them about 2-3mm from the holes
.4ohm twisted 28g kanthal and cotton wick. on a Grand Vapor Trident. the juice guzzler
Can I humbly post my first tank set up... First coil I made Ss mesh with 32 Kanthal 2.2 ohm
^ Looks good to me man! How are you liking that particular genny? I've been thinking of picking one up now that prices have gone down a bit.
- Status
Similar threads
