Post pictures of your working wick and coil setup

Status
Not open for further replies.

BuzzKilla

Ultra Member
ECF Veteran
Verified Member
Nov 4, 2010
2,036
2,152
Etobicoke, Ontario
www.graindeep.etsy.com
SS mesh is the only way....

I shall keep the sacred tradition alive!
IMG_20140227_093834.jpg
 

bigmaaark

Super Member
ECF Veteran
Sep 14, 2013
303
288
rancho cucamonga, ca
nice! im running 28 gauge, hovering around .4 ohms. dont have an ohm checker at work to show you lol. do you have any issues with the positive post moving up so it doesnt contact the pin? i replaced my delrin insulators with teflon and sometimes the post moves up into the atty and doesnt contact the pin in the mod. it gets frustrating! i gotta tap it back down and it ruins builds because sometimes i tap to much lol. any advice?
 

BuzzKilla

Ultra Member
ECF Veteran
Verified Member
Nov 4, 2010
2,036
2,152
Etobicoke, Ontario
www.graindeep.etsy.com
yeah, i've found that to be a small issue with mine too.

my mods pin is adjustable, so i just snug it up.

i am mindful of this, so i havent had it move on me in a while. it was a big annoyance when i first got it though.....
I haven't changed the insulators on it yet. So i dont know if that would make it better or worse.

being gentle goes a long way,
that being said, i have been on the hunt for a centre pin with a flanged bottom that would alleviate my hulk arms from moving it.
 

bigmaaark

Super Member
ECF Veteran
Sep 14, 2013
303
288
rancho cucamonga, ca
yes i have found that being real gentle with screwing the atty into the mod has helped as i havent had to mess with the post. i also have an adjustable pin on my mod, but even sometimes the post gets pushed so for up into the mod that the pin just hits the insulator lol.

ive read that you should change the top insulator to teflon, leave the bottom one delrin. i changed both to teflon. probably why mine moves more freely. has something to do with the friction delrin offers to keep the post in place versus the teflon. i dunno. still happy with the turbine, when it works properly lol
 

Jjshbetz11

Super Member
ECF Veteran
Mar 15, 2013
917
1,015
45
Ohio
Just play it safe man.....hopefully you know the in's and outs of battery safety. even if you do, I would advise only pulse firing that build. I am totally against this build in every way but I gotta ask.....how's she vape? That cotton has to be crying for juice after each pull! What size air holes! You gotta be bigger than 4mm I would think?
 
Status
Not open for further replies.

Users who are viewing this thread