Post pictures of your working wick and coil setup

[BubbaNubba]

OK, I'm going to jump in on this ...

Ladies and Gentlemen I give you, The Cleveland Steamer...

400 mesh wrapped with 28ga Kanthal on and IGO-l = 0.8ohm




This thing hits like truck full of trucks

 

[Vego]

Forecast for Vancouver: Rain.

Nice clouds, man!

 

[pdib]

↑↑ That build is nice! . . . . . . but . . . . . . . . .you do know what a Cleveland Steamer is . . . . .? . . . . . . . . don't you?

 

[jasl90]

↑↑ That build is nice! . . . . . . but . . . . . . . . .you do know what a Cleveland Steamer is . . . . .? . . . . . . . . don't you?

Can't wait to see the "Dirty Sanchez" build...

 

[pdib]

That's in the "hey, watch this!" sub-forum, discount batteries section

 

[Tanks]

Ohhhhhh, you are difficult!

Holy ....! What gauge is that wire?

Sent from my SAMSUNG-SGH-I337 using Tapatalk 2

 

[pdib]

Probably 26. Don't remember if its Nichrome or Kanthal; probably Kan.

 

[Amish3006]

First coil ever! Vapes like crap. Lol

 

[Jeremy Evans]

First coil ever! Vapes like crap. Lol

Your coils are probably too far apart

 

[Amish3006]

Your coils are probably too far apart

Probably. I've got a spool of kanthal and a sheet of mesh on the way. I'm sure I'll be practicing for a while to get it just right.

 

[ToneLic]

Kinda hard to tell but it's a quad coil on the new A6 rba. Just set it up today after seeing the dudes at vapelyfe's setup. Coils coming in at .3 ohms. I can only take about 4 puffs before I'm on the floor haha guess its time to lower my nicotine

 

[Jerms]

Where did you get that A6? Mine from EmpireMods is the same but with only one negative post.

Sent from my LGL55C using Tapatalk 2

 

[ToneLic]

I got it from discount vapors

 

[Jerms]

I got it from discount vapors

Cool thanks. It says at DV the cap has two air-holes too. Are they located at opposite ends of the cap?

Sent from my LGL55C using Tapatalk 2

 

[Jeremy Evans]

Everybody going crazy low ohms needs to make sure they are using the right batteries

 

[pdib]

YEPYEP. Check your max discharge ratings, kids!

 

[Judge Dredd]

http://i.imgur.com/MNIJk8e.jpg
http://i.imgur.com/eyUXyh5.jpg

I really need to work on my photography.

 

[omen304]

first working micro coil...
twisted 30 gauge. 12 wrap. 2.8 ohm
takes a second to heat up and sends my evic into temperature warning after the second draw. intense...

 

[ToneLic]

Cool thanks. It says at DV the cap has two air-holes too. Are they located at opposite ends of the cap?

Sent from my LGL55C using Tapatalk 2

Yea. It has them on each side of the cap. I was worried I might have to drill them out a little bigger but they seem to be fine

 

[Elnroth]

Chobra!