-
Need help from former MFS (MyFreedomSmokes) customers
Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?
View thread
Loving my 2nd stack on the Dreamer.. Had an issue after a build of .27 on the coil master tab and pre heating the coils.. after wicking it it ohmed out at .29.. after several hits on it.. It was just so freaking hot.. Thought I would recoil and go a bit higher... just for kicks I checked the ohms again and it was .19... I was like Whoa..especially using it in a tube stack..any ideas on how that could have dropped like a rock on the ohms?
This is perfect for the smaller flavor concentrate bottles although I may need another one since I’ve got 15 more on the way from Nic River! Thanks to whoever it was that posted the link somewhere. I keep the larger bottles in the refrigerator.
Build a lot higher. 1.5 ohms still hits hard as hell on a series. You are rocking about 280 watts with that coil.
I did.. Build that's in it now .32..It's still a beast with the Samsung 30Ts but just don't know what caused the ohms to drop from .27 to .19... a bit scary.. All post screws were tight as well as the 510 pin..
Based on Ohms law I can go down as low as .26..with 35 amps at 7.4 Volts
Possibly had a hot spot you didn't see and heating and cooling the coils a couple of times could have worked it out. Could be several things.
.32 is still about 250 watts. Be careful. Series mods are no joke. I don't mess with unregulated series personally. Use the ohms calculator and see what wattage you are pushing. Figure it at 8.4 volts.I don't know why it dropped that much but you are lucky the wick didn't burst into flames on you or worse. Much worse.
The thing is you are wasting the power with a sub ohm build. Put as much coil mass as will fit. The stacked batteries have plenty of power to heat any coil. More surface area =more vapor production and cooler vapor.
Ha!
I just went Van Helsing on an Android app that was sucking my battery dry in a matter of a few hours, even with the screen off. I couldn't figure it out.
So I installed Accubattery and let it run, and it found the vampire.
Outlook. Microsoft product. Go figure.
So I go to uninstall it and it won't let go--When you install it, it gets phone admin privileges and commences to take over everything. Calendar, mail, alarms, everything. And you can't force stop, kill or uninstall until you manually drill down to the security settings and remove its privileges.
Gone now, and my battery charge level has barely budged since. Well, 5% but that's four hours.
No more charging 2x or 3x a day.
I just went Van Helsing on an Android app that was sucking my battery dry in a matter of a few hours, even with the screen off. I couldn't figure it out.
So I installed Accubattery and let it run, and it found the vampire.
Outlook. Microsoft product. Go figure.
So I go to uninstall it and it won't let go--When you install it, it gets phone admin privileges and commences to take over everything. Calendar, mail, alarms, everything. And you can't force stop, kill or uninstall until you manually drill down to the security settings and remove its privileges.
Gone now, and my battery charge level has barely budged since. Well, 5% but that's four hours.
No more charging 2x or 3x a day.
Have 1 more Mech tube coming called the Overpowered Mod..Uses a 30mm RDA..It is sweet, has a delryn insulator inside the tube and stack..
The coils I posted earlier is what you need. Put any build you want to try in it and dial it up to 7.4 or 8.4 for feesh batteries and see how it vapes.
Here are a few series builds
It may be safe where you are building but you will get a much better vape with more coil mass.
I'm not surprised that was a screamin' deal.Sold out
Similar threads
- Locked
- Locked
- Locked
