classwife

Admin
Admin
Supporting Member
ECF Veteran
Verified Member
May 9, 2010
98,564
161,088
68
Wesley Chapel, Florida
I did the same thing when I tried some crab flavored liquid at one. :danger:


Won't get me to try that one :lol:
Pizza isn't bad for a taste here and there, but I wouldn't want to vape a tank of it.
 

lupinehorror

bròn
Supporting Member
ECF Veteran
Verified Member
Jul 11, 2017
3,265
22,602
Dunblane
remembered i have a tsunami 25mm bottom air flow rda kicking around. it shall be coiled tomorrow and paired with the ehpro armor. will rebuild the vls too though 24mm and the underhang irks slightly much like all the other 24mm atties.
 

Rangertrix

Vaping Master
ECF Veteran
Verified Member
Dec 5, 2013
3,873
15,454
Collinsville, OK
Won't get me to try that one :lol:
Pizza isn't bad for a taste here and there, but I wouldn't want to vape a tank of it.

"Try it" they said.
"It tastes better than it smells" they said.
NOPE!!

Not sure if I could bring myself to try 'pizza', lol.
 

TrollDragon

ECF Guru
ECF Veteran
Dec 3, 2014
10,556
57,665
NS, Canada
remembered i have a tsunami 25mm bottom air flow rda kicking around. it shall be coiled tomorrow and paired with the ehpro armor. will rebuild the vls too though 24mm and the underhang irks slightly much like all the other 24mm atties.
I have an OG Tsunami in the box of meh RDA's, such a lovely thing it is to squonk on... :facepalm:

How's the VLS? Be good for a single cell squonker?
 

Rangertrix

Vaping Master
ECF Veteran
Verified Member
Dec 5, 2013
3,873
15,454
Collinsville, OK
I have an OG Tsunami in the box of meh RDA's, such a lovely thing it is to squonk on... :facepalm:

I have several RDAs I mean to get BF screws for and I just never seem to do it.
I kinda want to try one of my old Freakshow Minis on a squonker and I'm not sure if I want to dremel it since I've been too lazy to order any screws.
Maybe I'll see if one of my Velocity bf ones will fit, lol.
 

lupinehorror

bròn
Supporting Member
ECF Veteran
Verified Member
Jul 11, 2017
3,265
22,602
Dunblane
I have an OG Tsunami in the box of meh RDA's, such a lovely thing it is to squonk on... :facepalm:

How's the VLS? Be good for a single cell squonker?
the tsunami isn't the best rda but width and finish fit.
the vls? much bang for buck. single, dual, vertical, horizontal, squonks... currently around £11 on FT. well worth the proverbial punt.
 

Rangertrix

Vaping Master
ECF Veteran
Verified Member
Dec 5, 2013
3,873
15,454
Collinsville, OK
Absolute TRASH, not even worth $10.

I'd spend $10 if shipping was free, lol.
Just to play with it for a day or two and then give it away.
I know plenty of people I don't care if the gear I give them is crappy. :D
 

TrollDragon

ECF Guru
ECF Veteran
Dec 3, 2014
10,556
57,665
NS, Canada
I'd spend $10 if shipping was free, lol.
Just to play with it for a day or two and then give it away.
I know plenty of people I don't care if the gear I give them is crappy. :D
There is always that.
I don't even show people the Evod's we have here at the shop for $5. A terrible experience vaping (Evod) is no way to start down the road to getting off smokes.
 

stols001

Moved On
ECF Veteran
May 30, 2017
29,338
108,119
LOL I won two of those (IJoy but not squonk 2700 battery mods) I gave one to the husband and one to the kid. I love IJoy tanks but this had this large screen and it was so... rickety. LOL. I knew I'd kill them in weeks. They both use them though on occasion.

LOL, officially cleared by Pdoc as Convict Safe Material. Most of our visit was spent haggling over how much anti-tremor med to take. LOL. He wanted 10 m.g. I was like, "how about 5?" He looked dubious and said, "Well, couldn't you tell them you are on allergy meds or something?"

"NO. I don't want THAT kind of interview, I want there to be less problems, not more. Seriously, dude last time I took it I felt like I was wearing concrete boots."

LOL he finally told me to take 5 and in an hour, if it wasn't good to take more."

I feel this inner, ah, serenity but I sure hope it doesn't turn into Buddha like serenity, LOL, that dude is Dead. I think it will be okay.

I wish I'd had more time to prepare for this experiment but MAN, well, it is what it is. Leaving in 10 minutes. My pdoc was late, and there's all this roadwork near my house. Good times.

Anna
 

TrollDragon

ECF Guru
ECF Veteran
Dec 3, 2014
10,556
57,665
NS, Canada
I have several RDAs I mean to get BF screws for and I just never seem to do it.
I kinda want to try one of my old Freakshow Minis on a squonker and I'm not sure if I want to dremel it since I've been too lazy to order any screws.
Maybe I'll see if one of my Velocity bf ones will fit, lol.
I've converted every RDA I have (that's physically possible) over to squonk. Even drilled a hole dead center up through the press fit positive 510 post on the E-Phoenix Resurrection V1 (no 510 screw). ;)
 

Rangertrix

Vaping Master
ECF Veteran
Verified Member
Dec 5, 2013
3,873
15,454
Collinsville, OK
There is always that.
I don't even show people the Evod's we have here at the shop for $5. A terrible experience vaping (Evod) is no way to start down the road to getting off smokes.

Nowadays, that is so true.
When I started vaping, Joyetech eGos, carts, and horrible Chinese e liquid was all there was.
A Joyetech eGo kit with 2 650 mAh batteries, charger, an atomizer, and 5 carts cost me about $89 USD. :shock:
When all in one low resistance (1.5 ohm) cartomizers came out, I was the shiznit!! :lol:
That damn Joyetech eGo tank and atty kit never worked for crap though. Just dumped liquid everywhere. You might get 3 draws before tank dumped. :-x

There are so many better kits for starting out now.

You made me actually pull out an old eGo and MT3S for kicks. Still works, but no flavor and it's like trying to suck the chrome off of a trailer hitch (insert raunchy joke here).
Not to mention the only one I found right off the bat was a pink one. At least the MT3S was black. :confused:
 

Rangertrix

Vaping Master
ECF Veteran
Verified Member
Dec 5, 2013
3,873
15,454
Collinsville, OK
LOL I won two of those (IJoy but not squonk 2700 battery mods) I gave one to the husband and one to the kid. I love IJoy tanks but this had this large screen and it was so... rickety. LOL.

How does everyone win stuff but me? Even if it's crappy stuff!! :-x
 

TrollDragon

ECF Guru
ECF Veteran
Dec 3, 2014
10,556
57,665
NS, Canada
Nowadays, that is so true.
When I started vaping, Joyetech eGos, carts, and horrible Chinese e liquid was all there was.
A Joyetech eGo kit with 2 650 mAh batteries, charger, an atomizer, and 5 carts cost me about $89 USD. :shock:
When all in one low resistance (1.5 ohm) cartomizers came out, I was the shiznit!! :lol:
That damn Joyetech eGo tank and atty kit never worked for crap though. Just dumped liquid everywhere. You might get 3 draws before tank dumped. :-x

There are so many better kits for starting out now.

You made me actually pull out an old eGo and MT3S for kicks. Still works, but no flavor and it's like trying to suck the chrome off of a trailer hitch (insert raunchy joke here).
Not to mention the only one I found right off the bat was a pink one. At least the MT3S was black. :confused:
We sell a ton of Aspire K3 kits and Aspire Pocket X's, tried and true performers.

The wife and I started with a pair of Evod's, and two bottles of juice. The ....... at the B&M (only one around at the time) who sold them to us pocketed $160 that day... Last dime he ever got from me or anyone I told as well.

The Evod didn't work for me, gurgly leaking mess was all it was. Worked for the wife but she could relight a smoke six times after putting it out in one of those little cubes. ;) I lit six smokes off of each other...

That evolved to a Kanger Genitank, oh look that's just an Evod with more liquid to leak and gurgle... The Nautilus Mini came next and it was what got me set on the path of vaping. The Nauti worked great until it was getting too hard to get it apart to fill, which seemed to be a common problem as they started to wear.

Stopped in at a new B&M on the way home one night and picked up my first Kayfun (Heatvape 3.1es). Well that changed everything and haven't used a blister pack coil since those days.
 

TrollDragon

ECF Guru
ECF Veteran
Dec 3, 2014
10,556
57,665
NS, Canada
Digging through old posts on FB... Kayfun Mini 2.1 in extended mode... Sit back and vape like a sir! :lol:

Too go back to those days in 2014...
Stick.jpg
 

Users who are viewing this thread