I checked that one out but I mostly go for dual coil rda’s.
Sent from my iPhone using Tapatalk
The blue dani mini has arrived!
Fortunately, round two was easier than setting up the first one. It’s a daunting menu system till you get used to it. Much like a Provari, once you get the hang of it, it’s fine... it’s the getting the hang of it that’s frustrating at best, but that may be because I’m firmly right brain.
I hope you Love your little blue dani mini
I can't wait for a mini blue picture
Dual coil -The Wotofo Nudge (24mm) is underrated but has great flavour and for classic dual coil RDAs it's hard to go past the original Drop. If you like bottom air and don't need squonk then the Kennedy is a true classic. You can get good clones if you use them.
The Aspire Odan tank came in , it's big but I think it pairs nicely with the Amighty.
I'm so jealous! The Dani mini is way up the top of my wish list but too expensive for me at the moment.The blue dani mini has arrived!
Fortunately, round two was easier than setting up the first one. It’s a daunting menu system till you get used to it. Much like a Provari, once you get the hang of it, it’s fine... it’s the getting the hang of it that’s frustrating at best, but that may be because I’m firmly right brain.
I've been using mine daily since February and I haven't noticed any decrease in the performance of my batteries. Even if there was some effect, the amount of time I've saved charging would more than make up for it. I can load it up with four 30Ts at half charge or so each and they'll all be at 100% by the time I think to check on them. I've never timed it specifically but it's probably less than an hour and a half for quarter to half charged batteries.
I mainly use mechs, so I usually put my batteries on the charger when they hit around 70% which is when the power output decrease starts to become noticeable. It's less than an hour for sure from there, maybe half an hour or 20 minutes. I've probably never timed it because it's never been enough of an issue to make me feel like I should. Usually, I'll put a battery or two on, get distracted with something and by the time I look again they're done.
Most batteries are around $5-8 each. I've never killed one in the years since I started using 18650s, 20700s and 21700s but if I did, I still think the time savings would be worth it. Also, the charger has a chip that regulates the output based on battery conditions, so there's really minimal worry I'm hurting anything. In a nutshell, I asked myself what my time was worth and concluded that it's worth more than waiting hours for my old D4 to finish topping up my batteries.
For a classic design that has loads of flavor, I'd say CSMNT all day long. Since you can't get them anymore, the C2MNT is just as good with all the minor gripes from the original sorted. Easy build, outstanding flavor and the top cap stays cool. Really hard to beat.
Do you have a Kennedy?
I have the clone that came with the Vindicator clone setup.
Sent from my iPhone using Tapatalk
Yes. Yes I have 2
You don't like that one?
(Tralfaz's suggestion is a great one I'm sure.. just asking)
You all know my photography skills are meh, but here they are! I’m running a test on how long a zenith coil lasts using unflavored, so they’re not wearing their proper tanksI hope you Love your little blue dani mini
I can't wait for a mini blue picture
. I don’t think I’ve loved a mod this much since my provaris. And creme de vape’s 10% off didn’t hurt! 
You all know my photography skills are meh, but here they are! I’m running a test on how long a zenith coil lasts using unflavored, so they’re not wearing their proper tanks
ohhh pretty!
It’s ok. The flavor is good but not very defined. I’ll use Dinner Lady LT as an example. In the Pulse v2 I get lemon tart all the way but with the Kennedy clone I get lemon and pastry...not bad, just different.
Sent from my iPhone using Tapatalk
Great article. Looks like good news finally.
Vape Shops Likely to Be Exempted in Planned FDA E-Cig Curbs
Vape Shops Likely to Be Exempted in Planned FDA E-Cig Curbs
I have an Axial and really enjoy it. Here’s what I’m working with...yeah I keep a list on my phone ha ha.
Black Mvrket LA, black
Dead Rabbit, black
Dead Rabbit, gray
Dead Rabbit, purple
Dead Rabbit clone 24mm, red
Dead Rabbit SQ, black
Dead Rabbit SQ, rainbow
Drop Dead, black
Drop Dead, bloody mess
Drop Dead, rainbow
Kennedy Vindicator clone, black
Mass Mods Axial, ss
Oumier Wasp Nano, black
Steam Crave Glaz v2, black
Vandy Vape Bonza, black crinkle
Vandy Vape Pulse v2, black
Sent from my iPhone using Tapatalk
Similar threads
- Locked
