Desk Check! Onegin with engraved Dvarw, Abyss with Ether Bridge, Abyss with Flow V2, Stratum Submariner with Monarchy rta, Stratum Aerodynamic with Dvarw DL. Red Pill, Blimey, Red Pill, Waves and Red Pill.
I wish my vapes looked half this good. Not even talking about the kind they are, just so clean and all matchy. I am apt to be running around with a hairband holding the battery door on and a cracked drip tip.
Tap on the calculator to get to the recipe side. Like elr they have 2 sides. Great group over there.
Vaping Community - Discussions on Vaping
Just joined....the interface is a bit difficult to navigate but looks good otherwise....
All us vapers are a good bunch
Happy Hump Day, shinies <3
Welp, Texas finally thawed out and my clearance Nunchaku Mod/RDA Kit from Stan showed up. This is a pretty nice little 24mm dual coil RDA. The mod tops out at 80W which isn't my usual cup o' tea but I went ahead and installed the coils it came with and it turned out to be a pretty nice little vape all maxed out I'm diggin' it. Not too shabby for twenty bucks 
Welp, Texas finally thawed out and my clearance Nunchaku Mod/RDA Kit from Stan showed up. This is a pretty nice little 24mm dual coil RDA. The mod tops out at 80W which isn't my usual cup o' tea but I went ahead and installed the coils it came with and it turned out to be a pretty nice little vape all maxed out
I'm diggin' it. Not too shabby for twenty bucks 
You looking for vape forums like ECF ???
There's Ecig Vape Forum South Africa, Planet of the Vapes UK, VU (has MANY ex-ECF'ers). I'm a member at those. Australia has a few decent vape forums. There are quite a few more on the interwebz.
For wicking have a look at Ange's blog. Dvarw RTA Wicking Techniques | E-Cigarette Forum
I switch off between Exocet and the Vapdivrr methods. I prefer a wick that is "tight" in my coils. And I switch off between cotton and rayon all the time with my RBA's. Both work well in the Dvarw's.
When screwing the tank section on the deck go counter clockwise until you feel it click into the threading. Then push lightly on the deck while screwing them together.
Top cap - generously lube the small o-ring on the top of the cap. If it still gets stuck try replacing the larger lower o-ring. That should help it to stay attached to the Peek section when you unscrew the tank section. If that doesn't work try the o-ring at the top of the cap. On my authentic's the caps never gets stuck.
Also, the Peek section, FL's only, is keyed to mate with the positive post. It only fits one way. Make sure it is fully seated.
Flavor - try lowering your coil over the airflow insert. I have mine set at ~1.5mm above the AF. You could also experiment with raising your coil but you will get a stronger throat hit, which you may or may not enjoy.
I run my Dvarw DL FL with both 3mm and 2.5mm ID coils. Both work well for me.
Lately I've been running my Dvarw DL FL with a 3mm ID coil.
With the Vapdivrr wicking method I cut my tails right at the edge of the deck. For Exocet I trim them at about 0.5mm outside the juice flow holes on the chimney.
Whatever wicking method you are using the key is to make sure the tails are completely covering the chimney juice holes. So you can't see any light through them.
I have 8 Colossi ( @Zazie
) and only tore a battery wrap once. It was on my first go with one.In the Asmodus thread I learned from @DeloresRose and @AngeNZ and @bigbob2322 how to insert the battery without tearing it.
Partially insert the negative side of the battery first - then push up and in while inserting the positive side. Works like a charm. Give it a try.
Same goes for removing the battery. Push up towards the negative while pulling out.
I haven't tore a battery wrap since.
Morning shinies
Nah, I leave the saturation well alone. Only contrast and temperature. I'm still very much learning the camera though - it seems to have a high saturation in lower light which I want to tone down.
Even the cheapo ones at FT seem to survive better than some manufacturers original wraps for me. But I mainly get them for the cool pictures, and to keep track of the battery's age
$1.87 Iwodevape 18650 Battery Sleeve PVC Heat Shrinkable Tube Wrap - authentic / 10pc/pack at FastTech - Free Shipping
Nah, I leave the saturation well alone. Only contrast and temperature. I'm still very much learning the camera though - it seems to have a high saturation in lower light which I want to tone down.
Even the cheapo ones at FT seem to survive better than some manufacturers original wraps for me. But I mainly get them for the cool pictures, and to keep track of the battery's age
$1.87 Iwodevape 18650 Battery Sleeve PVC Heat Shrinkable Tube Wrap - authentic / 10pc/pack at FastTech - Free Shipping
Betcha I'm way slower than you.An infant can type faster than I can
Would bet that an infant, Carli dog and Angel cat are all faster than I.
Who was that super intelligent Gorilla? Bet he/she is/was way faster than me too.
I typez in the slow lane.
I'm relieved that the latest installment of this saga is so uplifting. I didn't like the turn toward tragedy earlier.
If you open the site in Chrome, you can translate it. Some of the word choices might make you laugh, but you'll get the gist.
Similar threads
- Locked
