I got a Tripod and another a
kayfun.
The conclusion of my drama: I checked for loose legs and stray bits of wire. Didn't find anything: legs trimmed flush, screws tight, and coil stable. Grimm Green said it wasn't necessary to install the air flow control, so I hadn't bothered with it, but I stuck it in just to see if for some reason that would make a difference. Put the reassembled atty back on the ohm reader: no reading at all. Stuck it on the Colossal: reading 1.27 ohms and
vaping fine. I thought maybe the tab had been damaged somehow, but it read another atty, which I knew had a .5 ohm coil, with no problem. I think the plastic air flow insert in the Kayfun insert interferes with the connection somehow, which is stupid and annoying.
At least it's working and the vape is lovely (good thing: I bought five more of them without even trying the one I had). But I am worn out. I had already struggled building the Project X (I found the sunken deck difficult to work with) so I went into the job tense and tired. Wrapping the coil, installing it, and wicking went extremely well, however, so I was pretty happy. Then that error message showed up. Much swearing ensued. All's well that ends well and all that, but I am now ready to take a nice hot bubble bath to calm down.
Thanks for the advice, everyone. It helped. See you after I soak a while.
I think you'll really like it.
