VAMO skin templates with multiple configuration options

[erebel]

Since I could only post 5 picks on my last post here are the others.

 

[Stoneface]

Since I could only post 5 picks on my last post here are the others.

Nice job again There is a little bit of a learning curve with getting a nice fit (I used the paper print out first to fit mine).

That is a great tribute to your service

 

[Spike64]

View attachment 221892Years ago, I was in the U.S. Army. In 1983 I was stationed at Camp Stanley, South Korea. This is my tribute to my service. their. Left side shows U.S. Flag next to the buttons and the led window as well as a 2nd ID logo on the lower battery extension. Top band shows unit affiliation of the 1/15 th FA. Section below the buttons shows the 1/15th FA crest. Right side shows South Korean Flag opposite the U.S. Flag along with another 2nd ID patch below on the battery extension. In the center of the battery extension is a map of South Korea detailing the U.S. Bases located in South Korea. The battery lid says "Camp Stanley South Korea 1983 - 84". I solved problems with the button fitment, used the suggested tip to use the DCT carto tank to punch out the fire button stated earlier in this thread. I used a tapered pick to punch out the smaller buttons and then shaved the tags that came out the back with a razor blade. but, I rushed cutting it out so it's not even on the backside. View attachment 221893Left side View attachment 221890Lower battery extension centerView attachment 221889Lower right battery extension.

Looks great!.....and thank you for your service

 

[Tammerz]

Peraspera will this template work on the vamo v3?

 

[Stoneface]

Peraspera will this template work on the vamo v3?

You can download the file and print it on regular paper and use that to test fit the pattern to your Vamo V3. I did that with my Vamo V2 because there were some variations in build (as there are likely variations in the V3 build as well). Good luck with it

 

[peraspera]

Peraspera will this template work on the vamo v3?

I don't have a v3 and don't plan on getting one so I won't be able to make a template specifically for the v3. However, tweaking the v2 to fit the v3 as Stoneface suggests might be a tad easier than doing a template from scratch. If you don't already have a vector drawing program you can use the open source Inkscape.

 

[Tammerz]

Thank you both very much! I will give it a try