Evolv- Replay Mode Coming Soon to a Mod Near You

[untar]

Escribe 2.0 SP13 is out but Replay is only available for the 250c at the moment
Final SP13 ist raus! | DNA200 German Crew

 

[eGoisti]

LostVape starts with paranormal 250C model. Didnt know, that with this new chip, you can use your mod as a powerbank?

 

[ShowerHead]

LostVape starts with paranormal 250C model. Didnt know, that with this new chip, you can use your mod as a powerbank?

Given a choice between vaping and powering a phone, I’m vaping.

 

[JoeyC]

How do you find out what version of board is in the mod?

 

[mackman]

One way connect the mod to Escribe, go to Get Information in upper left hand corner and you will get the serial # and other info. Open the Device Monitor in the lower right hand corner you will see the firmware info

 

[JoeyC]

One way connect the mod to Escribe, go to Get Information in upper left hand corner and you will get the serial # and other info. Open the Device Monitor in the lower right hand corner you will see the firmware info

Thanks

 

[rifky]

When it available on 75c? I am really waiting for small compact device with high tech

 

[Robfisher]

When it available on 75c? I am really waiting for small compact device with high tech

No one knows because no one at Evolv is saying...

 

[untar]

I wouldn't count on the 75c version before the end of April.
Source: a cheap psychic session...

 

[Herrick]

I 100 % agree.He basically said it was aimed at people who do not use TC or are unhappy with it. You must also lose the safety features that TC brings regarding bad chemicals being produced at higher temperatures. Especially if that hit you like and save is at a higher temperature.
To me the focus should be on making TC more user friendly to the people not using it the right way now on DNA devices. I actually think it is simple with a little time and patience. I have not altered any of my settings in several months on six,soon to be seven DNA devices. A backwards step in my opinion but i would love to be proved wrong.

I'm unable to watch the video right now because I'm at work. A couple questions: why is the safety feature of TC lost when using Replay?

I've had bad luck using TC mode on my Therion & Aspire Speeder. The resistance reading drops a bit and the vape turns to crap with no warmth or flavor. I have to lock the resistance on the Therion in order to have a good TC vape. The Speeder "auto-locks" but the resistance eventually goes down to crap vape level. If I were to buy one of these new mods coming out, would the Replay feature help me?

 

[ShowerHead]

I've had bad luck using TC mode on my Therion & Aspire Speeder. The resistance reading drops a bit and the vape turns to crap with no warmth or flavor. I have to lock the resistance on the Therion in order to have a good TC vape. The Speeder "auto-locks" but the resistance eventually goes down to crap vape level. If I were to buy one of these new mods coming out, would the Replay feature help me?

Respectfully, no.
I've seen your problems with TC. Just stay with a nice power mode mod.

 

[Herrick]

Respectfully, no.
I've seen your problems with TC. Just stay with a nice power mode mod.

Ah well

 

[untar]

75C Replay is progressing. It is markedly more consistent than a week ago. We will get there

-James, Evolvapor forum

So they're on it, working to get it out. Sounds like there's still some problems so we'll have to be patient

<-me

 

[benley73]

When using TC mode are you just doing it via mod or by escribe , putting in the correct wire type CSV file for. That wire ,
Then using pre heat- boost to heat the wire / ramp the coil up before it hits temp. You can also choose how long for as well
then taking a draw is just like power mode ,
the fine tuning makes a good difference.
When using it just on mod only its usually not set up optimally so give weak lackluster vape ,
Take a bit of learning on escribe to do this on each presetting ,
but ones done drastically improves it ,
But most cannot be bothered to do so
Which is why there are turned off TC ,
Where as wattage is much simpler , an replay even more so,

Sent from my ONEPLUS A3003 using Tapatalk

 

[samuels]

Replay for the 75C is out:

Early Firmware and EScribe Suite

 

[mackman]

It works as advertised. SS316L coil now for updated themes.

 

[untar]

Trying to figure out how to show the Replay controls in the stock LV 75c Mirage theme and not getting far.
Any advice on a good read on this? My google-fu didn't show anything too useful (probably my fault ).
I've looked into a 250c theme (from dna200 german dna group) but can only see hidden elements visible under certain conditions, couldn't replicate that.

Edit:
Nvm, I uploaded a 250c theme successfully and it's now working. Apparently you could also upload the "default theme" of the SP15.

 

[Robfisher]

Replay on the DNA75C Boom!

 

[Robfisher]

Trying to figure out how to show the Replay controls in the stock LV 75c Mirage theme and not getting far.
Any advice on a good read on this? My google-fu didn't show anything too useful (probably my fault ).
I've looked into a 250c theme (from dna200 german dna group) but can only see hidden elements visible under certain conditions, couldn't replicate that.

@untar when you are in eScribe select restore defaults. Then tick on Replay Box. Replay will only work with a new theme.

 

[untar]

Yeah, a stock 75c theme won't do it. A 250c theme did work and on another device I selected the "default theme" under the theme tab. Both are working beautifully.