I don't like Gearbest due to past experience, but a good deal. If I had mine built and tested I would still be tempted..
Older Folks and Vaping Front Porch - Part 5
- Thread starter MikeE3
- Start date
- th_trl_thread_readers 0
- Status
There have been a lot of bad comments about them in different threads so I've never chanced it. Worse than FT ever was.
Sent from my LG-V700 using Tapatalk
I've dealt wid GB numerous times fer non-vaping items wid no issues. Don't know 'bout CS in dat I didn't need any. Shippin' 'bout da same as FT.
Some good deals in here.... 2018 Holiday Clearance Deals – Page 4 – VAPEHAPPY
I snagged the only Zenith tank. Ten bucks off. Thanks!
I've looked at some of their stuff but never really ordered from them. I'd never heard anyone who had. What's the deal is this Coppervape Skyline the new greatest atty around? I guess I'm gonna have to start payin atttention.
No, hardly new 
But as the vape scene becomes more and more either multi-coil room fogging tanks or blast of the past pods (ok, improved cig-a-like and carto ), good mtl tanks are getting harder to find.
For me, the Skyline is a nice "equivalent" to the KFL2, adding more air flow control, juice flow control, and top fill. So would likely be good for at least restricted DL, in addition to mtl use.
But as the vape scene becomes more and more either multi-coil room fogging tanks or blast of the past pods (ok, improved cig-a-like and carto
), good mtl tanks are getting harder to find.For me, the Skyline is a nice "equivalent" to the KFL2, adding more air flow control, juice flow control, and top fill. So would likely be good for at least restricted DL, in addition to mtl use.
Yep ... "equivalent" to the KFL2". That's just what I was looking for to replace Janet's stock of KFL2's. Something with a very similar vape experience but 'loose the screw driver'
at refill time.
Does anyone remember the Walnut Wood Trixie mod?
Has anyone else read that our mod chips will fail due to age?
Well, I think I have the 1st casualty. Going through, checking out stuff, deciding what to do with the massive amount of stuff I have that will never get used again. I put a battery in, the screen flashed a couple of times, then NOTHING. Tried 3 different 18650's, button top and flat, right side up and upside down, brown, blue and red . I only used it long enough to test (back in the day), then tucked it away safely, with all my other backups.
I found a 2013 thread about it, My Walnut wood Trixie mod just arrived!!!
A moment of silence please.
Has anyone else read that our mod chips will fail due to age?
Well, I think I have the 1st casualty
. Going through, checking out stuff, deciding what to do with the massive amount of stuff I have that will never get used again. I put a battery in, the screen flashed a couple of times, then NOTHING. Tried 3 different 18650's, button top and flat, right side up and upside down, brown, blue and red . I only used it long enough to test (back in the day), then tucked it away safely, with all my other backups.I found a 2013 thread about it, My Walnut wood Trixie mod just arrived!!!
A moment of silence please.
Attachments
If anyone could use or knows anyone that could use mods or toppers, please PM me.
I was apparently out of mind, when I was shopping (2012/13ish and beyond), and some of it is good stuff.
iTaste SVD, Zmax, IPV D2, eVic VTC, Cloupor mini, sale Provaries, Nautilus, generic Kayfuns with the fill port on the side. I have multiples of a few of these things.
PS....I have not tested the electronics on these things.
I was apparently out of mind, when I was shopping (2012/13ish and beyond), and some of it is good stuff.
iTaste SVD, Zmax, IPV D2, eVic VTC, Cloupor mini, sale Provaries, Nautilus, generic Kayfuns with the fill port on the side. I have multiples of a few of these things
.PS....I have not tested the electronics on these things.
That sounds mysteriously like some of the stuff in my vape closet! I think I might pass out if any of my provaris “pass away”. Can you open it up and see if there’s a loose connection somewhere?If anyone could use or knows anyone that could use mods or toppers, please PM me.
I was apparently out of mind, when I was shopping (2012/13ish and beyond), and some of it is good stuff.
iTaste SVD, Zmax, IPV D2, eVic VTC, Cloupor mini, sale Provaries, Nautilus, generic Kayfuns with the fill port on the side. I have multiples of a few of these things
PS....I have not tested the electronics on these things.
If you love it, maybe someone handy here could test it for you. That’s a distressing thought that boards really do have a life span. I only kept one mech
I hear you, the very first thing I PIFed years ago was the original Zmax. Never could make friends with that bugger.I don't love it, and is included in my giveaway
I seen it spoken of around ECF that the display screens could start dying after about 10 years or so. But I don't recall a lifespan being talked about for the main control boards.
- Status
Similar threads
