iTaste MVP v2 Owners Group
- Thread starter KnurledNut
- Start date
- th_trl_thread_readers 0
- Status
There's a pbusardo video that I just saw (earlier in this thread?) where he goes over the MVP thoroughly as he's known to do. When he gets to the "numbers part" of the video and shows the MVPs recorded volt/watt/ vs ohm performance....it seemed to really give you what you set it at when running a 2.0 ohm coil. I'll look to see if I can find it and post it for you.
Here it is. He goes over it's output numbers starting at about the 12:50 mark
Last edited:
Recently got a Vamo V5...read charger reviews...decided on a "Nitecore D4 Charger 2014 New Version"...best price I found $26.99...
http://www.amazon.com/Nitecore-Rech...F8&qid=1405282166&sr=1-6&keywords=Nitecore+D4
You know, while I like cats im more of a dog guy. But Ive got to say- cats are just pros at taking cool pictures...
Just FYI, I charged the MVP off my cell phone charger block ONCE and now it wont go above 4.1volts when I charge (even when charging off the laptop). I believe someone else mentioned having the same problem. Anyone else with this issue?
Ill throw up (an unfortunately catless) picture of my MVP later
Just FYI, I charged the MVP off my cell phone charger block ONCE and now it wont go above 4.1volts when I charge (even when charging off the laptop). I believe someone else mentioned having the same problem. Anyone else with this issue?
Ill throw up (an unfortunately catless) picture of my MVP later
seems like a very good choice, I've been eyeballin` that too...
when you read all about it, sounds like it has magic dust inside
the last version never had many complaints...
(be nice if it had a USB out)
and how could ya go wrong for under $30
- Dec 18, 2013
- 2,946
- 56,640
- 79
Yup. Works great.seems like a very good choice, I've been eyeballin` that too...
when you read all about it, sounds like it has magic dust inside
the last version never had many complaints...
(be nice if it had a USB out)
and how could ya go wrong for under $30
And FWIW, you haven't lived until u plugged a batt into a charger (the old nitecore) and it didn't work!!! Wiggling got it going, but letz not forget a backup charger as well!
But never thot of a usb on it. That wood bee awesum!!!
yepper, the wiggle bothers me...
you can buy a USB A/C wall adapter $3-$4 so they could just add it
and jack the price up a buck or two...
haha, yes back-up charger would be a must...
ever take one of those A/C adp apart ?
more tech inside than the Apollo 11 had...
It will top out at 11w and 4.57v... you cannot go over 11w, or 3amps, or 5v.. which ever you hit first is your limit. IE: If you had a 2.5ohm coil, the max you could go is 10w as it takes 5v to get there and 5v is a hard limit. Conversely, if you have a 1.2ohm coil, you could only do 3.6v because anything higher goes past both the 11w limit and the 3amp limit. It doesnt matter what mode you are in, these are hard limits.
OK so volts and watts are not independent of each other. Both values along with amps need to be under the max. So on my 1.8 coil that reads 1.9 if I set volts to 5 it will only run at 4.57 because that is the 11w max. I think I got it now. Thanks a bunch!
Exactly. In fact volts and watts are totally dependant (along with ohms, of course)! You can set one of them but not both and as Midniteowl stated, the hard limits of the device will limit the output if you're asking more of it that it can give. The pbusardo video that I posted earlier explains this pretty well....but I think you've got it.
Well can't add much but wanted to say something! When I started vaping it was with Dekang juices. The flavors were too strong and the nic was to high so I'd mix in 25% Walmart VG. That would get me down to 18 nic and the flavor to where I could handle it. Plus it was cheap compared to a lot of the designer type juices.
Dekang E-Juice 24mg
30 AWG wire showed up yesterday. Waiting on the Magma RDA and another Russian clone from Fasttech. A Hana clone and big Nautilus with bvc replacements coming too.
Dekang E-Juice 24mg
30 AWG wire showed up yesterday. Waiting on the Magma RDA and another Russian clone from Fasttech. A Hana clone and big Nautilus with bvc replacements coming too.
Off topic, has anyone seen the Clouper T5? It has firmware that can be updated. It is a 50 watt and scuttlebutt says the firmware update in Sept. Will make it 70 watts. This is the hi power device I have been looking for. I was eyeing the IPV 50, but the firmware updates has me sold.
Donesmokin, you're gonna LOVE the Magma!! I got mine last week and good LAW the flavor is RE-DICULOUS!! 
deleted post 
dang birds flying over my head again, anybody got a washcloth
dang birds flying over my head again, anybody got a washcloth
Last edited:
Well I pulled the trigger and just ordered an MVP v2. So ready to get away from the twists. Now the waiting game begins.
hey great, welcome to the big ta-do , MVP world...
what color ya get ? / 2 i16 or 1 i30 ?
life is better with an MVP
hey great, welcome to the big ta-do , MVP world...
what color ya get ? / 2 i16 or 1 i30 ?
life is better with an MVP
Thanks
I bought a black one with 1 i30
Not sure how much I will use the i30. I have many different tanks that I love already. I like my tank cracker juices and prefer the glass tanks.
- Status
Similar threads
