Must Try! ADM auto drip mod
- Thread starter SCOTTYBALLS
- Start date
- th_trl_thread_readers 0
- Status
Wow I tried this ... Lol you should have seen the spring inside ,,, now I got to get me some wire cutters,,, nothing else will work .... hahaha .... I found out the hard way 
Just a thought.... Plastic Springs hopefully someone else finds them useful.
And now I see this ..... Thanks
There is no hole there. When you get liquid in your mouth, it's because too much is getting into the atomizer chamber and running into the vapor vents along side the cart and back into the mouthpiece.
Look at the diagram. (This is using a straw instead of a spring.) Those long channels along the side are how the vapor gets to your mouth. The liquid reservoir isn't open to the mouthpiece directly.
Last edited:
I've been using the blue fish filter material with this spring mod., along with the straw mod.
Combining both of these mods, works great.
I finally have a cartridge that can supply the demand of my Prodigy.
My atomizer stays much cooler, compared to dripping. This should extend the life of my atomizer also.... sweet!
Combining both of these mods, works great.
I finally have a cartridge that can supply the demand of my Prodigy.
My atomizer stays much cooler, compared to dripping. This should extend the life of my atomizer also.... sweet!
Last edited:
So wow thank you. You were very helpful. I just did the mod, works great. Ushually I onlly get three drops of vaping (I constanlt have to add three dropd and three drops only.) How many drops will I get out of this? If I alow gravity to refill the the poly will it use up the whole resivour?
So Im confused. I thought I didn it correctly, but I keep getting liquid in my mouth....a lot of it. Is it possible that I didnt use enough poly material?
Yes. Try adding more poly or using a different material. You want it to act like a plug on the end of the cart. If it's dense just enough, it'll just get saturated with liquid, but not allow too much to go through.
Is there any reason why you couldn't cut the hollow shaft of a q-tip into several equal length bits and stick them in the cart? It seems to me that that would well up the excess liquid even better than a spring?
Spring.. straw... honestly, whatever you got.
I started with a spring, but it was discoloring my liquid. Went into the cabinet last night, fund a suitable straw size, cut it to length, notched the "bottom" and put it in there. Done. Works.
I started with a spring, but it was discoloring my liquid. Went into the cabinet last night, fund a suitable straw size, cut it to length, notched the "bottom" and put it in there. Done. Works.
The spring it just to hold up the filler from falling into the reservoir. Anything that would keep the filler at the end of the cart rather than IN the cart would work. The key is to take up as little space in the reservoir as possible. Just two even pieces of the hollow Q-tip "straw" should work just fine. Any more just takes up liquid space.
i love the ingenuity on display here guys!!!
...any follow-up on the straw, q-tip, plastic spring, or other "relatively safe" device for this mod?
how's the vapor production and how effective is the adm cart mod in terms of using all the juice?
...any follow-up on the straw, q-tip, plastic spring, or other "relatively safe" device for this mod?
how's the vapor production and how effective is the adm cart mod in terms of using all the juice?
Using the single drinking straw and BLUE scrubbie pad, I get about 15 drops in the cart and it's pretty dry when I need to refill. I don't need to top off at all - just refill with another 15 drops. The blue pad is holding up well, no funky taste, no burnt taste. Awesome vapor on the 510. I am getting a slight gurgle today, but I always seem to get that with round mouthpieces. I need to mod one of my whistle tips.
Last edited:
I bet a straw cut in half lengthwise would work (look like a "C" from the top), as well and take up even less room in the reservoir.
Kristin,
With the 901 whistle tips I am approaching 20 drops. I realize drop size is subjective. And size does matter... ;-)
With the 901 whistle tips I am approaching 20 drops. I realize drop size is subjective. And size does matter... ;-)
THIS IS A GREAT MOD! I gave up on filling carts and poly-fill all together shortly after starting to vape because to "top off" a dry cart took 3 drops because of all the liquid stuck at the bottom of the poly-fill. Dripping was just as easy, this has TOTALLY changed my mind! THANK YOU YOUR A LIFE SAVER!
Sorry for the OT. But, were you cam from? I am italian and you?
If you're addressing me, I'm in the U.S. (with my husband and 4 kids, lol.) I'm mainly of Irish & German heritage.
- Status
Similar threads
