Well guys I'm impressed with my Skyline. I went for it on the build with an Ni straight round wire 26 gauge 2.5 Id, 0.4 ohm and following the wicking method which you can watch on Mark Todd's video or see it described on the fasttech forums.
The coil compartment is really small which makes for fantastic flavour....dare I say it....but I'm getting slightly better flavour than in my Dvarw's but this is probably also due to the new build because there isn't much in it.
I had to thin my tails out a lot to be able to get the cotton between the air intake and the wicking port hole and have had no leaking so far. It's a RDL which is very slightly more restricted than the Dvarw DL but this may be down to cotton quantity and I'm going to try a bit less on the next wick change. Obviously juice control closed to top fill the tank and then I opened her wide open to vape although this may be reduced for MTL using higher ohm coils.
This tank is a really good buy for either the MTL or the RDL guys as it comes with two separate MTL inserts to reduce the coil air intake and of course you have a lot of flexibility with the airflow adjustment ring.
In my opinion this is one that everyone should have in their vaping kit selection and it gets a top recommendation from me.
Enjoy you guys and
@Redbird11 don't hesitate.....this one's got it all and it's dead easy to build on.
