Well, the sun is over the yardarm... somewhere!
Maybe a batch of bad or mis-marked coils? Do you have any way to measure them?
Maybe a batch of bad or mis-marked coils? Do you have any way to measure them?
Thanks Andria, I'm not able to adjust the power because it's a simple (lowly?) ego one. The juice is a fairly high vg so I think I'll dump it, try (yet another) new coil and some different juice and give 'er a whirl.
Unfortunately I don't @DavidOck. I actually tried 2 different coils from 2 different packs with the same result. Dang itWell, the sun is over the yardarm... somewhere!
Maybe a batch of bad or mis-marked coils? Do you have any way to measure them?
I have found high vg juice does not play well with the single coils.
You talking about the actual Kanger Top Fill Adapters? Heres some at the very bottom of the page.. I have never used one though.Was not me either. However I am interested in the top fill thingy for the STM. It might become my first FT order.
I am really liking my STM with the 1.2 coil. Perfect draw for me and the vape is just warm not hot at all.
I actually ordered a 5 pack of coils for it. Go figure...
will likely never use the .5 ohm coil that came with it, but who knows? Never say never.
Might see me in a twerking Klowd comp someday?
@#@*!!#!!...
Jinxed it...spoke too soon. Burnt
Where's that bottle of scotch?!!
@#@*!!#!!...
Jinxed it...spoke too soon. Burnt
Where's that bottle of scotch?!!
You either need a higher resistance coil (probably) or a thinner juice if you are using above a 50/50 juice.Any idea why my protank 2 coils keep burnin on my ego one? Put a new one in yesterday and 1/2 hour later...burnt. Tried another...burnt. If I take a short pull it's fine but a longer pull..burnt.
I've been absent for quite some time. So, hello again y'all!!!
You need a 2 or 2.2 ohm coil. Factory Kanger 1.8's are bad to burn on an unreg battery.Thanks Andria, I'm not able to adjust the power because it's a simple (lowly?) ego one. The juice is a fairly high vg so I think I'll dump it, try (yet another) new coil and some different juice and give 'er a whirl.
Digits crossed.
Thanks for the help everyone!
I remember I used to use 3ohm on my mechanicals back in the day. Don't really recall the reason why...but it seemed to work out pretty good for me. I was using my (usual) 85PG/15VG mix, however. I'm not a fan of VG, and only use a little to pump up the vapor a little and add a touch of "smoothness" to my juice.You need a 2 or 2.2 ohm coil. Factory Kanger 1.8's are bad to burn on an unreg battery.
Speaking of bad to the bone I came across this tremendous, and unknown to me, guitar player.
I'm thinking of the evic for a future purchase (after christmas). Either the vt or the vtc mini. The vtc has better specs, but I prefer the design on the vt. What to do?
Vapez