EDIT** For newer users, just as a reminder:
MVP 2 Voltage limits: 3.3 to 5 volts
MVP 2 Wattage limits: 6.0 to 11.0 watts
MVP 2 Amp limit: 3 amps ←───
vapor-lockd
well youve said all the right things AFAIC
the bloop, usually one big pow that makes the contents of the
tank swell and then a big bloop rises (tells me
tank was vapor-locked)
all my
tanks (I feel is SOP) throw small bubbles as I vape
ya burn it off, it replenishes creating bubbles in the process
wick inside coil wire
my point being, it looks as tho your wick doesnt fill coil ID
so I used the example, 2mm ID & 2.2mm wick OD
but your description is spot on AFAIC
"I pull the cotton through where its a little too stiff, then pull it back and forth until its snug but not tight"
Ive made about all combos, and thought maybe I needed something special
for the kayfun, but
duh, I just make the same coil I put in my kanger bccc
with the exception the wick is just slightly longer (just hangs over the edge)
5 wraps of 32ga around a toothpick yeilds 2.14Ω
I made so many 2.14Ω consistently, I thought my ohm meter went bad
air flow control
the key after all is said and done with the build
most adjust to please them-which is wrong-it is to allow device to function properly
different humans sucking, different juices, wick & coil size, power applied
(just because, have you taken your air screw all the way out, just to look ?)
also the center connection pin is hollow and houses your air channel
that damn air-flow, reminds me of power seats in a car, Im never happy with
setting and always goofin with it
what I do not like most about kayfun is once it is all together, thats it
no goofin with, either works, or not (mostly always does !)
guess I like to tinker with my bccs and RDA so the kayfun just bores me
Ive had great success with my kayfun, but just not that impressed (JMO)
my high performance bccs are just as good, but funner
--------------
ps: from the Innokin manual
5.Red LED light will stay on for 5 seconds when a load
short circuit is detected or the current of the coil is
more than
3.5A, then no more vapor will be produced.
if you have done as much work to your kayfun
as you have been typing, should be close to perfection...
good luck keep vaping
I'm a newbie, just got my iTaste MVP 2 yesterday and I'm loving this thing!!!
